600894
14
Zoom out
Zoom in
Previous page
1/76
Next page
14
1 Install the door control
Install the Door Control
To preventpossible SERIOUS INJURY or DEATHfrom electrocution:
Be sure power is NOT connected BEFORE installing door control.
ConnectONLY to 12 VOLT low voltage wires.
To preventpossible SERIOUS INJURY or DEATHfrom a closing garage door:
Install door control within sight ofgarage door, outofreach ofchildren at a minimum height of 5 feet
(1.5 m),and away from ALL moving parts ofdoor.
NEVER permit children to operate or play with door control push buttons or remote control
transmitters.
Activate door ONLY when it can be seen clearly,is properly adjusted, and there are no
obstructions to door travel.
ALWAYS keep garage door in sight until completely closed.NEVER permit anyone to cross path of
closing garage door.
INTRODUCTION
Compatible with MyQ
®
and Security+ 2.0™
accessories, see page 35. Your garage door
opener iscompatible with up to 2 SmartControl
Panels or 4 ofany other Security+ 2.0 door
controls. NOTE:Older LiftMaster door controls
and third party products are not compatible.
Install the door control within sight of the door at
a minimum heightof5 feet (1.5 m) where small
children cannot reach, and away from the
moving parts ofthe door.
NOTE: Your product may look different than
moving parts of the door the illustrations.
Screw
6ABx1"
HARDWARE
Drywall
Anchors
Screw
6-32x
1"
NOTE: For gang box installations it is not necessary to drill holes or install the drywall anchors. Use the existing holes in the gang box.
1.1 Strip 7/16 inch (11 mm) of insulation from
one end of the wire and separate the wires.
7/16"
(11
mm)
1.2 Connectone wire to each of the two screws
on the back of the door control.The wires
can be connected to either screw.
PRE-WIREDINSTALLATIONS:Choose
any two wires to connect, note which wires
are used so the correctwires are connected
at the garage door opener in a later step.
1.3 Markthe location of the bottommounting
hole and drill a 5/32 inch (4 mm) hole.
Wall
1.4 Install the bottom screw,allowing 1/8 inch
(3 mm) to protrude from the wall.
Screw
6-32 x 1"
DRYWALL
GANG
BOX
Screw
6AB x 1"
Drywall Anchor
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liftmaster 8587 Elite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liftmaster 8587 Elite in the language / languages: English as an attachment in your email.

The manual is 14,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info