600894
10
Zoom out
Zoom in
Previous page
1/76
Next page
10
To avoid possible SERIOUS INJURY from a
falling garage door opener,fasten it SECURELY
to structural supports of the garage.Concrete
anchors MUST be used if installing ANY brackets
into masonry.
HARDWARE
Hex Bolt 5/16"- 18x7/8"
Nut 5/16"-18
Lock Washer
5/16"
Hanging your garage door opener will vary
depending on your garage.Two representative
installationsare shown.Yours maybe different.
Hanging brackets should be angled (Figure 1) to
provide rigid support. On finished ceilings(Figure
2), attach a sturdymetal bracket to structural
supports before installing the opener. This
bracketand fastening hardware are not provided.
Instructions below are for attaching the garage
door opener directly to structural supports.
5.1 Measure the distance from each side of the
motor unit to the structural support.
5.2 Cut both pieces of the hanging bracketto
required lengths.
5.3 Drill 3/16" pilotholes in the structural
supports.
5.4 Attach one end of each bracketto a
supportwith 5/16"-18x1-7/8" lag screws
(notprovided).
5.5 Fasten the opener to the hanging brackets
with 5/16"-18x7/8" hex bolts, lock washers
and nuts.
5.6 Check to make sure the rail is centered
over the door (or in line with the header
bracketifthe bracket is not centered above
the door).
5.7 Remove the 2x4.Operate the door
manually. Ifthe door hits the rail,raise the
header bracket.
NOTE: DO NOT connect power to opener at this
time.
FIGURE 1
FIGURE 2
(Not Provided)
Lag Screws
5/16"- 18x1-7/8"
Measure
Distance
Hex Bolt 5/16"- 18x7/8", Lock Washer 5/16", Nut 5/16"-18
FIGURE 3
Not Provided
Finished Ceiling
Unfinished Ceiling
Installation
5 Hang the garage door opener
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liftmaster 8587 Elite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liftmaster 8587 Elite in the language / languages: English as an attachment in your email.

The manual is 14,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info