600889
24
Zoom out
Zoom in
Previous page
1/36
Next page
24
LIGHTS
Press the LIGHT button to turn the garage
door opener lights on or off. When the
lights are turned on they will stay on until
the LIGHT button is pressed again, or
until the garage door opener is activated.
Once the garage door opener is activated
the lights will turn off after the specifi ed
period of time (the factory setting is 4-1/2
minutes). The LIGHT button will not control
the lights when the door is in motion.
To change the amount of time the garage
door opener lights will stay on:
Press and hold the LOCK button until the
garage door opener lights fl ash. The time
interval is indicated by the number of
ashes.
NUMBER OF TIMES
GARAGE DOOR OPENER
LIGHTS FLASH
TIME THE
GARAGE DOOR OPENER
LIGHT STAYS ON
1 1 ½ Minutes
2 2 ½ Minutes
3 3 ½ Minutes
4 4 ½ Minutes
Light Feature
The lights will turn on when someone
enters through the open garage door and
the safety reversing sensor infrared beam
is broken.
Activate:
Start with the garage door opener lights
on. Press and hold the LIGHT button
until the garage door opener lights turn
off, then on again.*
Deactivate:
Press and hold the LIGHT button until
the garage door opener lights turn on,
then off again.*
* Approximately 10 seconds
Operation
PUSH BAR
Press the push bar to open/close the door.
LOCK
Designed to prevent operation of the door
from hand-held remote controls. However,
the door will open and close from the
Door Control, the Outdoor Key Switch,
the Keyless Entry Accessories and MyQ
®
Internet Gateway.
Activate:
Press and hold the LOCK button for 2
seconds. The command LED will fl ash
as long as the lock feature is activated
and your handheld remote control will
not operate your door at this time.
Deactivate:
Press and hold the LOCK button again
for 2 seconds. The command LED will
stop fl ashing and normal operation will
resume.
MOTION SENSOR
This feature will automatically turn on the
garage door opener lights when motion is
sensed. The lights will come on for 4-1/2
minutes, then shut off.
Activate/Deactivate:
Slide the motion sensor switch ON or
OFF.
Using the Door Control (MyQ
®
Control Panel)
NOTE: Due to power consumption this door control (Model 888LM) cannot be used in conjunction with another wired door control
connected to your garage door opener. If an additional door control is needed, the wireless door control model 885LM can be
programmed to the door control (Model 888LM). To program the 885LM to the MyQ
®
Control Panel, follow the remote control
programming steps.
NOTE: MyQ
®
light controls will continue to work however all other MyQ
®
devices and TTC will not work if using the Model 580LM
Alternate Power Supply or when in Battery Backup mode.
TIMER-TO-CLOSE (TTC)
The TTC feature automatically closes the
door after a specifi ed time period (1, 5,
or 10 minutes). Once the TTC has been
set and the door is open, the LED for the
selected close interval will blink and begin
to count down to close the door. The
control panel will beep and the garage door
opener lights will fl ash before closing the
door.
The TTC feature will deactivate if the garage
door encounters an obstruction twice; or
the safety reversing sensors are incorrectly
installed. The garage door will reverse open
and WILL NOT close until the obstructions
are clear or the safety reversing sensors are
correctly installed. When the obstruction
has been cleared or the safety reversing
sensors have been aligned, the door will
close when the garage door opener is
activated.
Activate:
Press and hold the ON button until
one of the TTC LEDs light up. Then
press the ON button again to cycle
through the time interval options (the
corresponding TTC LED will light
for each time interval). The garage
door opener light bulbs will blink as
confi rmation.
Deactivate:
Press and hold the OFF button until all
TTC LEDs turn off and a beep is heard
from the control panel.
To suspend the TTC:
To suspend the TTC and temporarily
hold the door open, press and release
the HOLD OPEN button (the HOLD
OPEN LED will turn solid). The TTC
will remain suspended until the HOLD
OPEN button is pressed again or the
garage door opener is activated from
another device (door control, remote
control, keyless entry, etc.).
LIGHT Button
HOLD OPEN
Button for the
Timer-To-Close
(TTC)
Motion Sensor
Push Bar
1 Minute
TTC LED
5 Minute
TTC LED
10 Minute
TTC LED
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liftmaster 8500 Elite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liftmaster 8500 Elite in the language / languages: English as an attachment in your email.

The manual is 5,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info