10
Operating Instructions
The electric replace can be operated by the switches on the front of the electric replace. As
soon as the electric replace is connected to a grounded socket and is placed
sturdy and stable, the On / Off switch can be switched on.
On / Off switch (ame switch): This switch turns the electric replace with ame effect on / off.
Heat setting: temperature setting | on and the heating element turns on at 1000W. Also press
mode || on and the heating element turns on at 2000W.
Thermostat setting: The button is marked with min.- and max. + To indicate the temperature
position. To decrease the temperature, turn the knob to the left, turn the knob to the right to
increase the temperature.
Flame damper: the knob is marked with min.- and max. + To indicate the intensity. To decrease
the intensity, turn the knob to the left, turn the knob to the right to increase the intensity.
Please note! Do not allow the replace to be covered or the air inlet / exhaust to be clogged
as the appliance may overheat! DO NOT place the replace on a carpet! Ensure that furniture,
curtains or other combustible material are positioned no closer than 1 metre from the Electric
Fireplace.
Assembling the Legs
Lay the Electric Fireplace upside down on a padded surface to avoid scratches to the surface of
your Fireplace.
Line up the holes in the legs with the holes on the bottom of the body.
Secure the legs with a screwdriver with the provided screws.
Overheating Safety Device
If the Electric Fireplace stops working, turn the it off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 10 minutes for the protection system to reset before at-
tempting to restart the heater. If the safe device still switches the heater off and makes the heater
fail to operate, take the heater to your nearest service center for examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at least 10 minutes.
-
-
-
-
-
-
1.
2.
3.
-
!
