13
MAINTENANCE
Cleaning
The recumbent bike can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the recumbent bike
after each use. Be careful not get excessive moisture on the computer display panel as this
might cause an electrical hazard or electronics to fail.
Please keep the recumbent bike, specially, the computer console, out of direct sunlight to
prevent screen damage.
Please inspect all assembly bolts and pedals on the machine for proper tightness every
week.
Storage
Store the recumbent bike in a clean and dry environment away from children.
TROUBLESHOOTING
PROBLEM: The recumbent bike wobbles when in use.
SOLUTION: Turn the rear stabilizer end cap on the rear stabilizer as needed to level the
recumbent bike.
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the computer console and verify the wires that come from the
computer console are properly connected to the wires that come from the front handlebar
post.
SOLUTION: Check the batteries are correctly positioned and battery springs are proper
contact with batteries.
SOLUTION: The batteries in the computer console may be dead. Change the new
batteries.
PROBLEM: There is no heart rate reading or heart rate reading is erratic or inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are secure.
SOLUTION: To ensure the pulse readout is more precise, please always hold on to the
handlebar grip sensors with two hands instead of just with one hand only when you try to test
your heart rate figures.
SOLUTION: Gripping the hand pulse sensors too tight. Try to maintain moderate pressure
while holding onto the hand pulse sensors.
PROBLEM: The recumbent bike makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the recumbent bike, please inspect the bolts and
tighten the loose bolts.
