710409
11
Zoom out
Zoom in
Previous page
1/14
Next page
When an incandescent bulb is used:
qUse an incandescent lamp with max. 15 W and E14 socket.
qPower supply (AC) and voltage at the operating point must
comply with the details on the rating plate (see 1 Appliance
at a glance) .
When a LED is used:
qUse only the original LED lamp from the manufacturer.
The lamp can be obtained through customer service or a
specialist dealer (see 6.4 Customer service) .
WARNING
Risk of injury from LED light!
The light intensity of the LED lighting corresponds to risk group
RG 2.
If the cover is removed:
uDo not look directly into the light at close quarters through
optical lenses. Doing so may damage your eyes.
WARNING
Fire hazard from the LED light!
If different LED lights are used, there is a danger of overheating
or fire.
uUse the manufacturer's original LED light.
If the lamp is defective, exchange it as follows:
uSwitch off the appliance.
uPull out the power plug or switch
off the fuse.
uAs shown in the diagram, press
open the lamp cover on the
inside at the front, and pull it off
to the side.
uReplace the lamp.
uPut on the lamp cover again and
snap it into place.
6.4 Customer service
First check whether you can rectify the fault yourself
(see 7 Malfunctions) . If you cannot rectify the problem, contact
Customer Services. You can find the address in the enclosed
Customer Service Directory.
WARNING
Unprofessional repair!
Injuries.
uHave any repairs and action - not expressly specified -
on the appliance and mains cable carried out by service
personnel only. (see 6 Maintenance)
uA damaged mains cable may only be replaced by the manu-
facturer, the manufacturer’s Customer Service or a similarly
qualified person.
uIn the case of appliances with an IEC connector, the change
may be made by the customer.
uRead the appli-
ance designation
Fig. 15 (1)
, service
No.
Fig. 15 (2)
and
serial No.
Fig. 15 (3)
off the model plate
located inside the
appliance on the left-
hand side.
Fig. 15
uNotify the customer service, specifying the fault, appliance
designation
Fig. 15 (1)
, service No.
Fig. 15 (2)
and serial No.
Fig. 15 (3)
.
wThis will help us to provide you with a faster and more accu-
rate service.
uKeep the appliance closed until the customer service
arrives.
wThe food will stay cool longer.
uPull out the mains plug (not by pulling the connecting cable)
or switch off the fuse.
6.5 Energy efficiency class lighting
Lighting
Energy efficiency class1Light source
This product contains an energy efficiency class
G light source
LED
1 The appliance may contain light sources with different energy
efficiency classes. The lowest energy efficiency class is indi-
cated.
7 Malfunctions
Your appliance is designed and manufactured for a long life
span and reliable operation. If a malfunction nonetheless
occurs during operation, check whether it is due to a handling
error. In this case you will have to be charged for the costs
incurred, even during the warranty period. You may be able to
rectify the following faults yourself:
Appliance does not work.
The appliance is not switched on.
uSwitching on the appliance.
The power plug is not properly inserted in the wall socket.
uCheck power plug.
The fuse of the wall socket is not in order.
uCheck fuse.
The compressor runs for a long time.
The compressor switches to a low speed when little cold is
needed. Although the running time is increased as a result,
energy is saved.
uThis is normal in energy-saving models.
A LED on the bottom rear of the appliance (at the
compressor) flashes regularly every 15 seconds*.
The inverter is equipped with a diagnostic LED.
uThe flashing is normal.
Excessive noise.
Due to the various speed steps, speed-regulated* compres-
sors can generate different running noises.
uThe sound is normal.
A bubbling and gurgling noise.
This noise comes from the refrigerant flowing in the refriger-
ation circuit.
uThe sound is normal.
Malfunctions
* Depending on model and options 11
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr TP 1424-21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr TP 1424-21 in the language / languages: English as an attachment in your email.

The manual is 1.68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr TP 1424-21

Liebherr TP 1424-21 User Manual - German - 16 pages

Liebherr TP 1424-21 User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info