597453
11
Zoom out
Zoom in
Previous page
1/14
Next page
u
Switch off the appliance.
u
Pull out the power plug or switch
off the fuse.
u
As shown in the diagram, press
open the lamp cover on the
inside at the front, and pull it off to
the side.
u
Replace the lamp.
u
Put on the lamp cover again and
snap it into place.
6.4 Customer service
First check whether you can correct the fault yourself by refer-
ence to the list (see 7) . If this is not the case, please contact
the customer service whose address is given in the enclosed
customer service list.
WARNING
Risk of injury if repair work is not carried out professionally!
u
Have any repairs and action - not expressly specified - on
the appliance and mains cable carried out by service
personnel only. (see 6)
u
Read the appliance
designation
Fig. 17 (1)
, service
No.
Fig. 17 (2)
and
serial No.
Fig. 17 (3)
off the type plate
located inside the
appliance on the left-
hand side.
Fig. 17
u
Notify the customer service, specifying the fault, appliance
designation
Fig. 17 (1)
, service No.
Fig. 17 (2)
and serial No.
Fig. 17 (3)
.
w
This will help us to provide you with a faster and more accu-
rate service.
u
Keep the appliance closed until the customer service
arrives.
w
The food will stay cool longer.
u
Pull out the mains plug (not by pulling the connecting cable)
or switch off the fuse.
7 Malfunctions
Your appliance is designed and manufactured for a long life
span and reliable operation. If a malfunction nonetheless
occurs during operation, check whether it is due to a handling
error. In this case you will have to be charged for the costs
incurred, even during the warranty period. You may be able to
rectify the following faults yourself:
Appliance does not work.
The appliance is not switched on.
u
Switch on the appliance.
The power plug is not properly inserted in the wall socket.
u
Check power plug.
The fuse of the wall socket is not in order.
u
Check fuse.
The compressor runs for a long time.
The compressor switches to a low speed when little cold is
needed. Although the running time is increased as a result,
energy is saved.
u
This is normal in energy-saving models.
A LED on the bottom rear of the appliance (at the
compressor) flashes regularly every 15 seconds*.
The inverter is equipped with a diagnostic LED.
u
The flashing is normal.
Excessive noise.
Due to the various speed steps, speed-regulated* compres-
sors can generate different running noises.
u
The sound is normal.
A bubbling and gurgling noise.
This noise comes from the refrigerant flowing in the refriger-
ation circuit.
u
The sound is normal.
A quiet clicking noise.
The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
u
The sound is normal.
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
The refrigeration increases automatically when fresh food
has just been placed in the appliance or the door has been
left open for a while.
u
The sound is normal.
The ambient temperature is too high.
u
Solution: (see 1.2)
Vibration noises
The appliance is not standing firmly on the floor. As a result
objects and adjacent units start to vibrate when the refriger-
ator is running.
u
Align the appliance using the adjustable feet.
u
Keep bottles and jars apart.
The outer surfaces of the appliance are warm*.
The heat of the refrigeration circuit is used to prevent
condensate from forming.
u
This is normal.
The temperature is not cold enough.
The door of the appliance is not properly closed.
u
Close the door of the appliance.
Insufficient ventilation.
u
Keep ventilation grille clear, and clean it.
The ambient temperature is too high.
u
Solution: (see 1.2) .
The appliance was opened too frequently or for too long.
u
Wait to see whether the appliance reaches the required
temperature by itself. If not, please contact the after sales
service (see 6) .
The appliance is too close to a source of heat (stove, heater
etc).
u
Change the position of the appliance or the source of heat.
The internal light does not come on.
The appliance is not switched on.
u
Switch the appliance on.
The lamp (if the model comes with an LED lamp) is faulty.
WARNING
Risk of injury from LED light!
The light intensity of the LED lighting corresponds to risk group
RG 2.
If the cover is removed:
u
Do not look directly into the light at close quarters through
optical lenses. Doing so may damage your eyes.
Malfunctions
* Depending on model and options 11
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr K 2814 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr K 2814 in the language / languages: English as an attachment in your email.

The manual is 0,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr K 2814

Liebherr K 2814 User Manual - German - 14 pages

Liebherr K 2814 User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info