597561

Liebherr GT 3632 Manual

5
Zoom out
Zoom in
Previous page
1/10
Next page
13
EN
Operating and control elements
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!
Saving energy
- Always ensure good ventilation. Do not cover ventilation open-
ings or grille.
- Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
- The energy consumption depends on the installation conditions,
e.g. the ambient temperature.
- Keep the time the appliance is open to a minimum.
- Store food logically.
- Keep all food properly packed and covered so as to avoid its
frosting up on the outside.
- Always allow hot food to cool to room temperature before placing
in the appliance.
- If there is a thick layer of frost in the appliance: defrost the appli-
ance.
Accumulated dust increases the energy consumption:
- Regularly clean the motor compartment ventilation openings to
keep them free from dust.
1
Temperature control
2
Operating lamp
3
Alarm lamp
4
Superfrost button
5
Superfrost lamp
Switching the appliance on and o
You are recommended to clean the appliance before switching
it on for the rst time (see "Cleaning").
To switch the appliance on
Connect the appliance to the mains > the appliance is switched on.
– The green operating lamp comes on.
– The red alarm lamp comes on.
The red alarm lamp goes out as soon as the freezer compart-
ment is cold enough.
To switch the appliance o
Pull out the mains plug or
set the temperature control to 0.
Important
When the temperature control is turned to "0", only the re-
frigeration system is switched o. Before cleaning, always
di s c o n n e c t t h e a p p l i a n c e f r o m t h e m a i n s . R e m ov e t h e p l u g .
Setting the temperature
Using a coin, turn the arrow on the temperature control to a set-
ting between 1 und 4.
When the control is turned to 4, the temperature inside the appli-
ance is at its lowest.
For long-term storage of frozen food a
temperature of at least -18°C is recommended.
If the chest is loaded up to a maximum of 300 mm below
the top level of the basket, the appliance can be set
to the 1 setting. This setting reduces the amount of
power consumed by your chest freezer even further.
The temperature should in any case be set so that if you place
a thermometer on the top of the frozen food it reads at least
-18°C.
Control elements
The red alarm lamp comes on if the temperature
in the freezer compartment is not cold enough.
This can be caused by:
• a long power failure;
• a fault in the appliance.
In each case, make sure food has not defrosted or perished.
The "Superfrost" lamp ➎ lights up when the "Su-
perfrost" facility is switched on for freezing large
quantities of fresh food (see "Freezing").
2 3 5
4
1
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr GT 3632 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr GT 3632 in the language / languages: English as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr GT 3632

Liebherr GT 3632 User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info