717089
22
Zoom out
Zoom in
Previous page
1/24
Next page
w
The display switches to the home screen. Arrows and the
temperature alarm symbol appear in the relevant tempera-
ture field
. In addition the messages symbol is
displayed in the menu field .
u
Check the food for quality. Do not consume spoiled food. Do
not re-freeze defrosted food,
u
Close the door.
w
The symbols are greyed out when the target temperature is
reached.
w
Appliances with a status display: While the status display is
activated, this lights up blue.*
If the alarm status persists or the temperature cannot be reset
independently:
(see 7 Malfunctions) .
Power cut
An audible warning sounds. The power cut symbol
appears on the display.
The temperature had risen too high over the last few
hours or days due to a power cut or power interrup-
tion. When the power is restored the appliance
continues to work at the last temperature setting. Acti-
vated reminders are retained.
u
Open the door.
u
Press the power cut symbol.
w
The audible signal stops. The warmest temperature reached
in the freezer compartment during the power cut is displayed
on the screen.
u
Press the screen or wait for 30 seconds.
w
The display switches to the home screen. Arrows and the
symbol temperature alarm appear in the relevant tempera-
ture field . The messages symbol is also shown in the
menu field .
u
Check the food for quality. Do not consume spoiled food. Do
not re-freeze defrosted food,
u
Close the door.
w
The symbols are greyed out when the target temperature is
reached.
Appliance faults
An audible warning sounds. The appliance fault
symbol appears on the display with the relevant error
code.
Appliances with a status display: When the status
display is activated and the door is closed, a red light
pulses at the same time.*
An appliance component indicates a fault.
u
Open the door.
u
Note down the fault code.
u
Press the appliance fault symbol.
w
The audible signal stops. The display switches to the home
screen.
u
Close the door.
w
Appliances with a status display: While the status display is
activated, this lights up blue.*
u
Contact Customer Services (see 6 Maintenance) .
Water inlet fault*
An audible warning sounds. The appliance fault
symbol appears on the display with the WATER error
code.
The water connection to the IceMaker is not open, the water
feed is interrupted or the filter in the water inlet hose connection
is blocked.
u
Open the door.
u
Press the appliance fault symbol.
w
The audible signal stops. The display switches to the home
screen. The IceMaker switches off.
u
Close the door.
u
Open the water connection.
-or-
u
Check the water connection and the hoses (see 4 Putting
into operation) .
-or-
u
Clean the filter.
u
Switch the IceMaker on (see 5.14.2 Switch the IceMaker
on.*) .
u
Contact Customer Service if the message persists
(see 6 Maintenance) .
Other messages
Clean the ventilation grille (see 6 Mainte-
nance)
*
Open, close IceMaker drawer*
9 Decommissioning
9.1 Switching the appliance off
Note
If the appliance cannot be switched off, the child safety device
is enabled.
u
Switch the child safety device off (see 5.2.2 Switching the
child safety device off) .
9.1.1 Switch off the appliance from the menu
The whole appliance is switched off. The screen goes black.
u
Press menu.
u
Press the navigation arrows until the standby symbol
is displayed.
u
Press OK.
w
The standby symbol flashes on the whole screen. The whole
appliance is switched off.
w
After 10 minutes the standby symbol goes out.
9.1.2 Switching the appliance off via the
freezer compartment field.
The screen remains on.
u
Press the freezer compartment field.
u
Press plus.
w
The plus symbol is greyed out if it is pressed again after
selecting the hottest temperature. The standby symbol is
displayed on the screen.
u
Press OK.
w
The standby symbol appears in the freezer compartment
field.
w
The appliance is switched off and the screen remains
switched on
9.2 Taking the appliance out of service
u
Empty the appliance.
u
Put the IceMaker in the cleaning position (see 6 Mainte-
nance) .*
u
Switch off the appliance (see 9 Decommissioning) .
u
Remove mains connector.
u
Remove appliance connector if required: Remove
and move from left to right at the same time.
u
Clean the appliance .
u
Leave the door open to prevent odour.
Decommissioning
22 * Depending on model and options
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr GNef 4335 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr GNef 4335 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr GNef 4335

Liebherr GNef 4335 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info