561379
10
Zoom out
Zoom in
Previous page
1/12
Next page
u
Read the appliance
designation
Fig. 7 (1)
,
service No.
Fig. 7 (2)
and serial No.
Fig. 7 (3)
off the type
plate located inside
the appliance on the
left-hand side.
Fig. 7
u
Notify the customer service, specifying the fault, appliance
designation
Fig. 7 (1)
, service No.
Fig. 7 (2)
and serial No.
Fig. 7 (3)
.
w
This will help us to provide you with a faster and more accu-
rate service.
u
Keep the appliance closed until the customer service
arrives.
w
The food will stay cool longer.
u
Pull out the mains plug (not by pulling the connecting cable)
or switch off the fuse.
7 Malfunctions
Your appliance is designed and manufactured for a long life
span and reliable operation. If a malfunction nonetheless
occurs during operation, check whether it is due to a handling
error. In this case you will have to be charged for the costs
incurred, even during the warranty period. You may be able to
rectify the following faults yourself:
Appliance does not work.
The appliance is not switched on.
u
Switch on the appliance.
The power plug is not properly inserted in the wall socket.
u
Check power plug.
The fuse of the wall socket is not in order.
u
Check fuse.
The compressor runs for a long time.
The compressor switches to a low speed when little cold is
needed. Although the running time is increased as a result,
energy is saved.
u
This is normal in energy-saving models.
SuperFrost is activated.
u
The compressor runs for longer in order to rapidly cool the
food. This is normal.
A LED on the bottom rear of the appliance (at the
compressor) flashes regularly every 15 seconds*.
The inverter is equipped with a diagnostic LED.
u
The flashing is normal.
Excessive noise.
Due to the various speed steps, speed-regulated* compres-
sors can generate different running noises.
u
The sound is normal.
A bubbling and gurgling noise.
This noise comes from the refrigerant flowing in the refriger-
ation circuit.
u
The sound is normal.
A quiet clicking noise.
The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
u
The sound is normal.
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
The refrigeration increases automatically when the
SuperFrost, function is activated, fresh food has just been
placed in the appliance or the door has been left open for a
while.
u
The sound is normal.
The ambient temperature is too high.
u
Solution: (see 1.2)
Vibratory noise.
The appliance is not fixed to the ground. The running of the
cooling unit therefore makes objects and adjacent furniture
vibrate.
u
Adjust appliance via the height-adjustable feet.
u
Move bottles and containers apart.
The SuperFrost symbol
Fig. 3 (5)
flashes together with the
temperature display.
There is a fault.
u
Please contact the after-sales service (see Maintenance).
DEMO shines in the temperature display.
The demo mode is activated.
u
Please contact the after-sales service (see Maintenance).
The outer surfaces of the appliance are warm*.
The heat of the refrigeration circuit is used to prevent
condensate from forming.
u
This is normal.
The temperature is not cold enough.
The door of the appliance is not properly closed.
u
Close the door of the appliance.
Insufficient ventilation.
u
Keep ventilation grille clear, and clean it.
The ambient temperature is too high.
u
Solution: (see 1.2) .
The appliance was opened too frequently or for too long.
u
Wait to see whether the appliance reaches the required
temperature by itself. If not, please contact the after sales
service (see Maintenance).
Too much fresh food was placed inside without SuperFrost.
u
Solution: (see 5.8)
The temperature is incorrectly set.
u
Set the temperature to a colder setting and check after 24
hours.
The appliance is too close to a source of heat (stove, heater
etc).
u
Change the position of the appliance or the source of heat.
Concentrated collection of ice on inside face at centre of
appliance cover.
This build-up of ice is normal. Due to physical properties,
ice concentrates inside the top of the appliance.
u
Remove the ice with a scraper tool.
8 Decommissioning
8.1 Switching off the appliance
u
Press the On/Off button
Fig. 3 (1)
until the display goes dark.
Release button.
w
If the appliance cannot be switched off, the child lock func-
tion is active (see 5.2) .
8.2 Taking the appliance out of service
u
Empty the appliance.
u
Switch off the appliance (see Decommissioning).
u
Remove mains connector.
u
Clean the appliance (see 6.2) .
u
Leave the door open to prevent odour.
Malfunctions
10 * Depending on model and options
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr G 1223 Comfort at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr G 1223 Comfort in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr G 1223 Comfort

Liebherr G 1223 Comfort User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info