710176
9
Zoom out
Zoom in
Previous page
1/10
Next page
17
9 Disposing of the appliance
The appliance contains some reusable materials
and should be disposed of properly - not simply with
unsorted household refuse. Appliances which are no
longer needed must be disposed of in a professional
and appropriate way, in accordance with the current
local regulations and laws.
When disposing of the appliance, ensure that the refrigeration
circuit is not damaged to prevent uncontrolled escape of the
refrigerant it contains (data on type plate) and oil.
u Disable the appliance.
u Pull out the plug.
u Cut through the connecting cable.
* Depending on model and options
Decommissioning / disposing of the appliance
The compressor runs for a long time:
- It switches to a lower speed when it requires a lower cooling
capacity, to save energy.
- SuperFrost is switched on.
A LED on the bottom rear of the appliance (at the
compressor) ashes regularly every 15 seconds*.
- The inverter is equipped with a diagnostic LED.
The ashing is normal.
External surfaces warm. The heat from the cooling circuit is
used to avoid condensate.
Faults that you can remedy yourself:
The appliance does not function:
- The appliance is not switched on.
u Plug the plug into the mains socket correctly, check fuse
Vibration noises, if the appliance is not set up rmly on the oor.
u Align the appliance with the adjustable feet.
Temperature is not cold enough:
- Appliance door is not fully closed.
u Close appliance door.
- Ventilation and aeration insucient.
u Clear and clean the ventilation grille.
- High ambient temperature
u see 1.2.
- Excessive quantity of fresh food stored without actuating
SuperFrost.
u see 5.6.4.
- The appliance was opened too frequently or for too long.
u Wait to see if the appliance goes back to the required
temperature by itself. If not, contact customer services (see
maintenance).
- Temperature set incorrectly.
u Set colder and check after 24 hours.
- Appliance is set up too close to a heat source.
u
Change the location of the appliance or adjust the heat source.
The interior light does not light up.
- Appliance is not switched on.
u Switch on the appliance.
- The door was open for longer than 15 minutes.
u Interior light switches o automatically if the door stays open
for approx. 15 minutes.
Icing up or condensate forming.
- The door seal may have also slipped out of its groove.
u Check the door seal.
With the following faults, contact customer
service:
- The door seal is defective or requires replacement for another
reason. Door seal exchangeable.
- DEMO is shown in the temperature display.
- LED lighting is defective or the cover is damaged.
WARNINGS:
Risk of injury due to electric shock!
Live parts are located under the cover.
Have the LED interior light changed or repaired only by the
customer service or by specialized personnel trained for the
purpose.
Danger of injury by LED lamp!
The light intensity of the LED lighting corresponds to risk group
RG 2.
If the cover is defective:
Do not look into the illumination with optical lenses from the
immediate proximity. This can cause injury to the eyes.
8 Decommissioning
8.1 Switching o the appliance
Note
u To switch o the entire appliance you only need to switch
o the freezer section. The fridge section is automatically
switched o with it.
8.1.1 Switching o the freezer section
u Press On/O button for the freezer section Fig. 11 (9) for at
least 3s.
The temperature displays are dark. The entire appliance is
switched o.
8.1.2 Switching o the fridge section
u Press On/O button for the fridge section Fig. 11 (1) for at
least 3s.
The interior lighting goes out.
The temperature display of the fridge section is dark.
Note
u If only the fridge section is to be switched o, e.g. during
holiday periods, always make sure that the temperature
display for the freezer section is illuminated.
8.2 Taking the appliance out of service
u Empty the appliance.
u Switch o the appliance (see “Decommissioning”).
u Unplug the mains plug.
u Clean the appliance (see 6.2).
u Leave the door open to prevent odour.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr CNPef 4313-21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr CNPef 4313-21 in the language / languages: German as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr CNPef 4313-21

Liebherr CNPef 4313-21 User Manual - Dutch - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info