Manual Liebherr CNef 4335 (page 13 of 28) (English)

716866

Zoom out

Zoom in

1/28

uCarefully lift up the plugs with a slotted screwdriver and

remove them.

Fig. 22 (1)

uInsert the plugs again on the other side of the door.

Fig. 22 (2)

uPosition the door from above onto the lower bearing pins.

Fig. 22 (3)

uInsert the centre bearing pin through the centre bearing

bracket into the lower door. Make sure that the catch mecha-

nism is pointing to the rear.

Fig. 22 (4)

4.3.9 Fitting the upper door

Fig. 23

uPlace the door on the centre bearing pins.

uAlign the top of the door with opening in the bearing bracket.

Fig. 23 (1)

uInsert the bolt and tighten with a T15 screwdriver.

Fig. 23 (2)

uFit the protective cover to protect the door: Insert the protec-

tive cover and check that it is attached to the door. If not,

insert the bolt fully.

Fig. 23 (3)

uInsert the plugs.

Fig. 23 (4)

4.3.10 Aligning the doors

WARNING

Risk of injury due to the door dropping out!

If the bearing parts are not screwed into place firmly enough,

the door may drop out. This may lead to severe injuries. What is

more, the door may not close and therefore the appliance may

fail to cool properly.

uScrew the turn hinges firmly into place with 4 Nm.

uCheck all of the screws and retighten if necessary.

uAlign the doors flush with the appliance housing using the

two oblong holes in the lower bearing bracket and centre

bearing bracket if needed. To do this undo the middle screw

in the bottom bearing bracket with the T25 tool supplied.

Undo the remaining screws a little with the T25 tool or with a

T25 screwdriver and align using the slotted holes. Undo the

screws in the middle bearing bracket with the T25 tool and

align the middle bearing bracket using the slotted holes.

uSupport the door: Take off the adjustable foot on the bearing

bracket using the open-ended wrench SW10 until it comes

into contact with the floor, then turn an additional 90°.

4.3.11 Fit the covers

Fig. 24

The door is open 90°.

uPosition the bearing bracket and engage. If necessary push

apart carefully.

Fig. 24 (1)

uPosition the panel on the side and click into place.

Fig. 24 (2)

Fig. 25

uSlide on the external cover.

Fig. 25 (1)

uClose the upper door.

Fig. 25 (2)

4.4 Insertion into a row of kitchen units

Fig. 26

For 600 mm wide appliances:*

Putting into operation

* Depending on model and options 13

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr CNef 4335 in the language / languages: English as an attachment in your email.

The manual is 1.63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr CNef 4335

Liebherr CNef 4335 User Manual - German - 28 pages

Liebherr CNef 4335 User Manual - Dutch - 30 pages

Liebherr CNef 4335 User Manual - French - 32 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Liebherr CNef 4335 Manual

Product: