597388

Liebherr CBNPes 3967 PremiumPlus Manual

23
Zoom out
Zoom in
Previous page
1/26
Next page
A quiet clicking noise.
→
The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
u
The sound is normal.
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
→
The refrigeration increases automatically when the Super-
Frost, function is activated, fresh food has just been placed
in the appliance or the door has been left open for a while.
u
The sound is normal.
→
The refrigeration increases automatically when the Super-
Cool function is activated, fresh food has just been placed
in the appliance or the door has been left open for a while.
u
The sound is normal.
→
The ambient temperature is too high.
u
Solution: (see 1.2)
A low hum.
→
The sound is produced by air flow noise of the fan.
u
The sound is normal.
Vibratory noise.
→
The appliance is not fixed to the ground. The running of the
cooling unit therefore makes objects and adjacent furniture
vibrate.
u
Adjust appliance via the height-adjustable feet.
u
Move bottles and containers apart.
Flow sound at the soft stop mechanism.*
→
The noise is produced when the door is opened and
closed.
u
The sound is normal.
The temperature display indicates: F0 to F9
→
There is a fault.
u
Please contact the after-sales service (see Maintenance).
The temperature display reads:FE
→
There is a fault.
u
Please contact the after-sales service (see Maintenance).
DEMO shines in the temperature display.
→
The demo mode is activated.
u
Please contact the after-sales service (see Maintenance).
The display indicates: POWER FAILURE. The audible
alarm sounds.
→
The freezer temperature rose too high over the last hours or
days due to a power failure or power interruption.
u
To switch off the warning beep: press OK button
Fig. 3 (3)
.
w
The display indicates the freezer temperature again.
u
If POWER FAILURE continues to be displayed: Please
contact the after-sales service (see Maintenance).
u
Check the quality of the food. Do not consume spoiled food.
The outer surfaces of the appliance are warm*.
→
The heat of the refrigeration circuit is used to prevent
condensate from forming.
u
This is normal.
The IceMaker cannot be switched on.
→
The appliance and therefore the IceMaker are not
connected.
u
Connect the appliance to the mains (see Putting into opera-
tion).
The IceMaker does not make any ice cubes.
→
The IceMaker is not switched on.
u
Switch on the IceMaker.
→
The drawer of the IceMaker is not properly closed.
u
Close the drawer properly.
→
The water connection is not open.
u
Open the water connection.
→
The water intake to the IceMaker has been interrupted.
u
Check the water connection (see Putting into operation).
u
Check the hosing (see Putting into operation).
→
The screen located in the end piece of the water intake
hose or the screen located in the connecting piece on the
appliance is blocked.
u
Clean the screens.
The IceMaker symbol flashes.
→
There is a fault.
u
Please contact the after-sales service (see Maintenance).
The display indicates: CHECK WATER SUPPLY. The
audible alarm sounds.
→
A fault of the IceMaker has occurred.
u
To switch off the warning bleep: press OK button
Fig. 3 (3)
.
w
The temperature and fault of the IceMaker are indicated in
the display.
u
Check whether a handling error has been made.
u
Please contact the after-sales service if it is not possible to
correct the fault (see Maintenance).
The display indicates: ICE CUBE TRAY CANNOT BE
EMPTIED. The audible alarm sounds.
→
A fault of the IceMaker has occurred.
u
To switch off the warning bleep: press OK button
Fig. 3 (3)
.
w
The temperature and fault of the IceMaker are indicated in
the display.
u
Check whether a handling error has been made.
u
Please contact the after-sales service if it is not possible to
correct the fault (see Maintenance).
The display indicates: SENSOR FAULT. The audible alarm
sounds.
→
A fault of the IceMaker has occurred.
u
To switch off the warning bleep: press OK button
Fig. 3 (3)
.
w
The temperature and fault of the IceMaker are indicated in
the display.
u
Check whether a handling error has been made.
u
Please contact the after-sales service if it is not possible to
correct the fault (see Maintenance).
The display indicates: MECHANICAL FAULT. The audible
alarm sounds.
→
A fault of the IceMaker has occurred.
u
To switch off the warning bleep: press OK button
Fig. 3 (3)
.
w
The temperature and fault of the IceMaker are indicated in
the display.
u
Check whether a handling error has been made.
u
Please contact the after-sales service if it is not possible to
correct the fault (see Maintenance).
The temperature is not cold enough.
→
The door of the appliance is not properly closed.
u
Close the door of the appliance.
→
Insufficient ventilation.
u
Clear ventilation grilles.
→
The ambient temperature is too high.
u
Solution: (see 1.2) .
→
The appliance was opened too frequently or for too long.
u
Wait to see whether the appliance reaches the required
temperature by itself. If not, please contact the after sales
service (see Maintenance).
→
Too much fresh food was placed inside without SuperFrost.
→
The temperature is incorrectly set.
u
Set the temperature to a colder setting and check after 24
hours.
→
The appliance is too close to a source of heat (stove, heater
etc).
u
Change the position of the appliance or the source of heat.
The interior light is not on.
→
The appliance is not switched on.
u
Switch on the appliance.
→
The door was open longer than 15 min.
u
The interior light automatically switches off if the door has
been open for about 15 min.
Malfunction
* Depending on model and options 23
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr CBNPes 3967 PremiumPlus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr CBNPes 3967 PremiumPlus in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr CBNPes 3967 PremiumPlus

Liebherr CBNPes 3967 PremiumPlus User Manual - German - 26 pages

Liebherr CBNPes 3967 PremiumPlus User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info