The controls will look like the following.
Remote Control Operations
1. START/STOP BUTTON
Operation starts when this button is pressed
and stops when the button is pressed again.
2. OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps
low, medium, high and CHAOS.
5. JET COOL / HEAT
Used to start or stop the speed cooling or heating.
(Speed cooling or heating operates super high fan
speed in cooling or heating mode.)
6. CHAOS SWING BUTTON
Used to stop or start louver movement and
set the desired up/down airflow direction.
7. ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
(See page 21)
8. TIME SETTING BUTTONS
Used to adjust the time. (See page 21)
9. TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained and
to cancel the Timer operation. (See page 21)
10. SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
(See page 21)
11. ENERGY-SAVING COOLING MODE BUTTON
(OPTIONAL)
Used to set Energy-Save in cooling mode.
12. ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
13. PLASMA(OPTIONAL)
Used to start or stop the plasma-purification function.
(See page 19)
14. HORIZONTAL AIRFLOW DIRECTION CONTROL
BUTTON (NOT ON ALL MODELS)
Used to set the desired horizontal airflow direction.
(See page 22)
15. RESET BUTTON
Used prior to resetting time or after replacing batteries.
16. 2nd F BUTTON
Used prior to using modes printed in blue at the bottom of
buttons. (See page 20)
17. AUTO CLEAN(OPTIONAL)
Used to set Auto Clean mode.