756265
44
Zoom out
Zoom in
Previous page
1/72
Next page
10
EN
Installation Place
Requirements
Location
5 cm 1 cm 1 cm
Level floor : Allowable slope under the entire
appliance is 1°.
Power outlet : Must be within 1.5 meters of either
side of the location of the appliance.
Do not overload the outlet with more than one
appliance.
Additional Clearance : For the wall, 5 cm: rear /1
cm: right & left side
Do not place or store laundry products on top
of the appliance at any time. These products
may damage the finish or controls.
WARNING
This appliance contains R290, a refrigerant
that is environmentally friendly but flammable.
Do not damage the refrigerant circuit, keep
open flame and ignition sources away from the
appliance.
NOTE
For better drying performance, please keep the
rear of the appliance away from wall.
Do not install the appliance where there is a
risk of frost or dust.
The appliance may not be able to operate
properly or may be damaged by freezing of
condensed water in the pump and drain hose.
Do not install the appliance next to a high-
temperature appliance like refrigerator, oven
or stove etc, which can cause poor drying
performance and programme duration, and
adversely affect the proper functioning of the
compressor. The appliance performs best at a
room temperature of 23 °C.
Positioning
Install the appliance on a flat hard floor.
Make sure that air circulation around the
appliance is not impeded by carpets, rugs, etc.
Never try to correct any unevenness in the
floor with pieces of wood, cardboard or similar
materials under the appliance.
Do not install the appliance in rooms where
freezing temperatures may occur. Frozen
hoses may burst under pressure. The reliability
of the electronic control unit may be impaired at
temperatures below freezing point.
If the appliance is delivered in winter and
temperatures are below freezing, place the
appliance at room temperature for a few hours
before putting it into operation.
Please ensure that when the appliance is
installed, it is easily accessible for an engineer
in the event of a breakdown.
With the appliance installed, adjust all four
feet using a spanner to ensure the appliance
is stable, and a clearance of approximately 20
mm is left between the top of the appliance and
the underside of any work-top.
Ventilation Requirement
WARNING
In the appliance enclosure or in the built-in
structure, keep ventilation openings clear of
obstruction. If not, it can result in a fire.
Alcove or under counter
Ensure air flow of 3.17 m3/min through the
appliance
Closet
Closet door must have 2 (louvered)
openings, each having a minimum area of
387 cm2, located 8 cm from bottom and top
of door.
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for LG RT8DIHP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of LG RT8DIHP in the language / languages: English, German as an attachment in your email.

The manual is 6,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info