7
Introduction
About the internal hard disk
drive
The internal hard disk drive (HDD) is a fragile piece of
equipment. Please use the recorder following the
guidelines below to protect against possible HDD
failure.
We recommend that you back up your important
recordings onto DVD discs in order to protect against
accidental loss.
Do not move the recorder while it is on.
Install and use the recorder on a stable, level
surface.
Do not block the rear vent/cooling fan.
Do not use the recorder in excessively hot or humid
places, or in places that may be subject to sudden
changes in temperature. Sudden changes in
temperature can cause condensation to form inside
the recorder. This can be a cause of HDD failure.
While the recorder is switched on, do not unplug
from the wall socket or switch the electricity off from
the breaker switch.
Do not move the recorder immediately after
switching it off. If you need to move the recorder,
please follow the steps below:
1. After the message POWER OFF is shown in the
display, wait at least two minutes.
2. Unplug from the wall socket.
3. Move the recorder.
If there’s a power failure while the recorder is on
there is a chance that some data on the HDD will
be lost.
The HDD is very delicate. If used improperly or in
an unsuitable environment, it is possible that the
HDD will fail after a few years of use. Signs of
problems include playback unexpectedly freezing
and noticeable block noise (mosaic) in the picture.
However, sometimes there will be no warning signs
of HDD failure.
If the HDD fails, no playback of recorded material
will be possible. In this case it will be necessary to
replace the HDD unit.
Using an USB Flash Drive
This unit can play the MP3 / WMA / JPEG files
contained in the USB Flash Drive.
Inserting/Removing the USB Flash Drive
Inserting the USB Flash Drive
Insert straight-in until it fits into place.
Removing the USB Flash Drive
Withdraw the USB Flash Drive carefully.
Notes:
Keep the USB Flash Drive out of reach of children.
If swallowed, seek medical advice immediately.
This unit supports only USB Flash Memory with
FAT16 or FAT32 format.
The USB Flash Drives which require additional
program installation when you have connected it to
a computer are not supported.
This unit is compatible with the Flash type USB
Flash Drive that supports USB 1.1.
This unit may not supports some USB Flash Drive.
Do not extract the USB Flash Drive in operating
(play, copy, etc.). It may cause a malfunction of
this unit.
Using the USB Flash Drive
1. Insert an USB Flash Drive.
2. Press HOME on the remote control.
3. Select [MUSIC], [PHOTO] or [MOVIE] option.
4. Select [USB] then press ENTER.
Details for the options are on page 16.
