613951

LG GP60NB50 Manual

7
Zoom out
Zoom in
Previous page
1/14
Next page
Installing the Drive
Before installing the drive, please note the following points.
■ You will need the following:
• A screw driver of a suitable size to fit the securing screws for the drive unit.
• The manual for the computer, so you can find the mounting positions for the
IDE controller cable.
■ Turn off all peripheral appliances of the computer and the computer itself, and
disconnect their power cords from the wall sockets.
■
Discharge any static electricity on your person by touching the computer covers, etc.
Removing the Computer Cover
Make sure all peripheral devices of the computer and the computer itself are turned
off, and then remove the cover. Refer to the manual for the computer for details about
removing the cover.
NOTE : There may be sharp edges inside the computer so take care to avoid injury.
Mounting the Drive
1. Remove the 5
1
/4″ drive bay panel from the computer. Refer to the manual for the
computer for details.
2. Insert the drive unit into the bay. Do not apply excessive pressure to the cables
inside the computer.
3. Secure the drive with the screws. If there is not enough space behind the drive,
connect the IDE and other cables before securing the drive.
NOTE : This is a general installation
guide. If your PC hardware appears
different, please consult your hardware
manual for installing peripheral devices.
Jumper Setup
Before installation, set the jumper connector on the rear panel.
The drive can be connected as the Master or Slave on an EIDE (ATAPI) interface.
When several (up to four) EIDE devices are connected, each must be set in a unique
way. Specific knowledge of hardware and software is necessary to install the drive.
4
R
E
A
D
R
EA
D
W
R
I
T
E
R
E
A
D
R
E
A
D
W
R
IT
E
NOTE : If two peripheral devices with the same
settings are both connected to the Primary or to
the Secondary EIDE bus, the host computer may
fail to run or may malfunction. Careful attention is
necessary.
MA: Master
SL: Slave
CS: Cable Select (CSEL)
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for LG GP60NB50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of LG GP60NB50 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info