ADVANCED FUNCTIONS
19
ENGLISH
Disabling auto restart
NOTE
!
If you press and hold the On/Off button
for 3 – 5 seconds instead of 6 seconds,
the unit will switch to the test operation.
In the test operation, the unit blows out
strong air for cooling for 18 minutes and
then returns to the factory default set-
tings.
Restarting the air conditioner
automatically
When the air conditioner is turned on again
after a power failure, this function restores
the previous settings. This function is a fac-
tory default setting.
1 Open the front panel.
- Pull out the lower section of front panel
and lift it up.
2 Press the On/Off button and hold it for 6
seconds.
- The unit will beep twice and the light on
the upper section of the inner cover
(fixed) will blink 8 times.
- To re-enable the function, press the
On/Off button and hold it for 6 seconds.
The unit will beep twice and the light on
the upper section of the inner cover
(fixed) will blink 4 times.
* The feature can be changed according to
type of model.
Operating the air conditioner
without the remote control
You can use the On/Off button of the indoor
unit to operate the air conditioner when the
remote control is unavailable. However, the
fan speed is set to high.
1 Open the front panel.
- Pull out the lower section of front panel
and lift it up.
2 Press the On/Off button.
- For cooling and heating models, the oper-
ation mode changes, depending on the
room temperature.
- For cooling-only models, the temperature
is set to 22°C (71.6°F).
