Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Flip-up door
(opened)
Heating Operation
Signal transmitter
•
Cooling Model( ), Heat Pump Model( )
ON
OFF
CANCEL
SET
1
3
9
10
5
6
4
2
7
11
8
13
15
12
14
16
6
About the remote control on the system
Operating
Instructions
The remote control transmits the signals to the system.
Features of the Remote Control
Operation Mode
START/STOP BUTTON
Operation starts when this button is pressed
and stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
ROOM TEMPERATURE SETTING
BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps
low, medium, high and CHAOS.
JET COOL
Used to start or stop the speed
cooling. (Speed cooling operates
super high fan speed in cooling mode.)
CHAOS SWING BUTTON
Used to stop or start louver movement and
set the desired up/down airflow direction.
ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation. (See page 13)
TIME SETTING BUTTONS
Used to adjust the time. (See page 14)
TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time
is obtained and to cancel the Timer
operation. (See page 14)
SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
(See page 14)
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling
or heating. (See page 15)
ROOM TEMPERATURE CHECKING
BUTTON
Used to check the room temperature.
PLASMA(OPTIONAL)
Used to start or stop the plasma-purification
function. (See page 12)
HORIZONTAL AIRFLOW DIRECTION
CONTROL BUTTON
(NOT ON ALL MODELS)
Used to set the desired horizontal airflow
direction. (See page 15)
RESET BUTTON
Used prior to resetting time or after replacing
batteries.
2nd F Button
Used prior to using modes printed in blue at
the bottom of buttons. (See page 13)
