691925
129
Zoom out
Zoom in
Previous page
1/217
Next page
If the printer has separate floor-standing optional trays or output options attached to it, then disconnect
them before moving the printer.
If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over
thresholds and breaks in
flooring.
If the printer does not have a caster base but is
configured
with optional trays or output options, then remove
the output options and lift the printer o the trays. Do not try to lift the printer and any options at the same
time.
Always use the handholds on the printer to lift it.
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
Keep the printer in an upright position.
Avoid severe jarring movements.
Make sure that your fingers are not under the printer when you set it down.
Make sure that there is adequate clearance around the printer.
Note: Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to http://support.lexmark.com or contact customer support.
Saving energy and paper
Configuring power save mode settings
EcoMode
1
From the control panel, navigate to:
> Settings > > Device > > Power Management > > EcoMode >
2 Select a setting.
Sleep mode
1
From the control panel, navigate to:
> Settings > > Device > > Power Management > > Timeouts > > Sleep Mode >
2 Enter the amount of time that the printer stays idle before it enters Sleep mode.
Maintaining the printer 129
129


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lexmark MX321 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lexmark MX321 in the language / languages: English as an attachment in your email.

The manual is 12,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lexmark MX321

Lexmark MX321 User Manual - German - 211 pages

Lexmark MX321 User Manual - Dutch - 209 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info