9
Note: If the line output of your external device is connected, you only need to adjust the
system’s volume control. If your external device’s headphone output is connected, you may
need to adjust the volume control on both your external device and TT-43 achieve the
desired volume.
Listening to the Radio
RADIO MODE
1. Set the Mode selector to the FM position.
2. Select the desired radio station by turning the Tuning knob.
3. Adjust the volume to the desired level.
4. When finished listening to the radio, set the Mode selector to the Phono position to
turn off the radio.
Note: The receiver has a built-in FM antenna hanging at the rear cabinet. This wire should be
fully uncoiled and extended for best reception.
BLUETOOTH MODE
1. Set the Mode selector to the BT position. The Power Led Light Indicator will begin to
flash BLUE.
2. Turn your external device’s Bluetooth Setting ON. Wait a moment, then look for the
Bluetooth pairing name “ TT-43”
3. Select the Bluetooth pairing name, to connect the unit. Once connected, the BLUE Led
light will stop flashing.
4. You are now connected to your external device via Bluetooth
5. The best is to put the volume level on your Bluetooth device (smartphone or tablet) on
the maximum and adjust the desired listening volume with your turntable volume
control switch.
CONNECT THE TT-43 TO EXTERNAL ACTIVE SPEAKERS OR EXTERNAL HIFI SET
Connect the RCA Output Jack to the external speaker system with the RCA cable (not
provided) to enjoy vinyl records music on your speaker system.
HOW TO REPLACE THE NEEDLE
To replace the needle, please refer to the instructions below.
Removing the needle from the cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in direction “A”.
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction “B”.
2. Push the stylus upward as in direction “C” until the stylus locks into the tip position.
