803309
13
Zoom out
Zoom in
Previous page
1/122
Next page
- 13 -
Power supply adaptor:
Manufacturer: BRIGHTPOWER OPTOELECTRONIC TECHNOLOGY CO., LTD
Model number: SW1200500-FM
Input voltage: 100-240V
Input AC frequency: 50/60Hz
Output voltage: DC 12V
Output current: 0.5A
Output Power: 6W
Average active efficiency: 79.62%
Efficiency at low load (10%): 70.40%
No load Power consumption: 0.073W
Use only the power supply listed in the user instructions
Troubleshooting
There is no power
Power adaptor is not connected correctly.
No power at the power outlet.
Power is on, but the platter does not turn
Need to switch the Speed/STOP button to 33 or 45 to start playing.
Turntable’s drive belt is not installed or has slipped off.
The unit automatically switched in standby mode, power ON again.
Turntable is spinning, but there is no sound, or sound not loud enough
Stylus protector is still on.
Tone arm is lift up by the lever.
The Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo system’s line input.
Forget to connect the speaker to the turntable.
Distorted of inconsistent sound from one or both channels:
-Turntable is connected to wrong input of amplifier.
-Needle or cantilever damaged.
-Drive belt overstretched or dirty.
-Platter bearing without oil, dirty or damaged.
-Dust on stylus.
-MM/MC switch on pre-amplifier set incorrectly.
Record sounds too fast or too slow
Wrong speed selected for the record.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lenco LBT-225 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lenco LBT-225 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 1.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info