601898
4
Zoom out
Zoom in
Previous page
1/25
Next page
4
ASSEMBLY
Drive belt:
The belt and turntable platter have been installed properly at factory, but the belt
may be loose during transportation. If so, the following procedures will be taken for
belt installation by yourself.
A. Remove the E ring clip from the turntable shaft, and then release the turntable
platter from the shaft
B. Put the drive belt on the inner rim of the turntable platter and pull it through the
hole
C. Hold the belt with your fingers and place the belt onto the motor pulley as
shown in the drawing.
D. Clip the E ring on the shaft and place the rubber mat onto the turntable platter.
Caution:
1. Make sure that the drive belt is not twisted or distorted.
2. Do not oil. Oil splashes will make the belt slippery.
Adjustment of the platter speed:
1. Set the arm lift lever to the up position.
2. Set the speed select switch to either 33’ or 45 according to the speed of the
record to be played.
3. Release the arm clip and move the tonearm toward the turntable platter/ The
turntable will start revolving.
4. Observe the appropriate strip of strobe calibration dots.
5. If the strobe dots appear to flow to the right it means the platter is revolving
slower than the rated speed. If the strobe dots appear to flow to the left, then
the platter is revolving faster than the rated speed. There are two speed
adjustment holes on the bottom. Adjust in until the strobe dots appear to be
stationary.
6. After the platter speed has been adjusted correctly return the tonearm to the
arm rest and fix the arm clip.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lenco L-84 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lenco L-84 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lenco L-84

Lenco L-84 User Manual - German - 27 pages

Lenco L-84 User Manual - Dutch - 26 pages

Lenco L-84 User Manual - French - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info