17
Configure Menu
Choosing the option you want from the Configure Menu
1. Press the SELECT button.
( Note: If you make a mistake at any point ,press BACK button to go back to the previous screen.)
2. Press Tune Up or Down until ‘Configure’ is displayed
3. Press the SELECT button.
4. Press Tune Up or Down until the display shows the option you want.
5. Press the SELECT button to choose the option shown on the display. The options are
explained below.
<Network Config>
Enables you to configure your radio’s network settings, scan again for a connection to another
wireless network , or to manually configure the network parameters. This is useful if you take the
Internet radio to another building where you want to use.
Once the radio has established a certain type of connection to the network, then this type of
connection will remain in use while the radio is on.
<Version>
Displays the versions numbers of the various parts of software the hardware on you Internet radio.
<Firmware Upgrade>
Use this option to download new firmware for the radio from the Reciva portal on the internet. If
there is new firmware available, the radio will prompt you if you want to download it or not. Note, at
this stage, you can press the radio’s BACK button to cancel the radio beginning a firmware
upgrade. A firmware upgrade may take several minutes, so do no switch off the power to the radio
until the operation is complete otherwise the radio may become permanently damaged.
<Language>
Allows you to change the display language.
<Factory Reset>
Puts all the setting back to their default as they were when they left the factory. If you perform a
factory reset on your radio you will loss all you presets and your wireless network connection.
<Register>
This will display a key that can be used to register the radio on the Reciva Customer portal.
<Clock>
Use this option to set the time, to set an alarm and to view the current alarm setting, see’’ Setting
the clock’’, ‘’Setting the alarm’’.
<Sleep Timer>
Selecting this option will enable the Internet radio to switch itself off after a set period.
1. After selecting the ‘Sleep Timer’ menu item, the radio will display: ‘ Sleep Timeout’ and the
sleep timer value in the form ’00:00:00’(hours : minutes : seconds).
2. Press Tune Up or Down to change to sleep timer value and then press SELECT to begin the
sleep timer.
3. The radio will continue to play as normal, but it will go into standby mode after the sleep timer
has expired.
4. To turn the radio back on again, simply press the ON/OFF button.
<Backlight>
Selecting this option will alter the internet radio’s backlight values.
