10
please note that the external device will play when selecting Aux and the right
radio station is selected when selecting FM.
11. Confirm the wake up source by pressing the Alarm 1 button (19).
12. Finally set the desired maximum wake up volume. Use the Previous (12) and
Next (10) buttons to set the wake up volume.
When the alarm sounds, the alarm will sound 60 minutes. After 60 minutes, the
alarm stops and it will sound again on the next day.
Snooze, interrupt the alarm
When the alarm sounds, it can be temporarily interrupted. Interrupt the alarm by
pressing the Snooze button (1). When snooze is activated, the alarm will resume
after 9 minutes. Using the snooze function is possible for up to 60 minutes after the
set alarm time. After 60 minutes, the alarm stops and it will sound again on the next
day.
Disable the alarm for 24 hours
If you want the alarm to stop and continue on the next day, press the Power button
(13).
Disable the alarm
Press the Alarm 1 button (19) to disable alarm 1. Press the Alarm 2 button (18) to
disable alarm 2.
Radio mode
This device has an FM radio with a wire antenna for receiving radio signals. If you
want to listen to the radio, first fully extend the wire antenna. If the signal is weak,
adjust the position of the antenna to find the best reception. Contact your local
service provider for a frequency list of the radio stations that can be received in your
area.
Turning the radio on
Press the Power button (13) to turn the device on. If the radio is not in radio mode,
press source (13) until the display shows "Rad". Once "Rad" has disappeared, the
frequency and the band (FM) are shown on the display.
Finding a station / frequency
You can use manual tuning or automatic tuning when searching for a radio station.
To automatically search for a station with a frequency higher than the current
frequency, hold the next button (10) for 3 seconds. To automatically search for a
station with a frequency lower than the current frequency, hold the previous button
(12) for 3 seconds. Once the tuner has found a station with sufficient signal strength,
it will stop scanning automatically.
To manually switch frequency or to fine tune, briefly press the previous button (12) to
lower the frequency with steps of 0,05 MHz. Briefly press the next button (10) to
increase the frequency with steps of 0,05 MHz.
