601867

Lenco BOOST-8 Manual

6
Zoom out
Zoom in
Previous page
1/60
Next page
EN-5
2. "T" shows on the LCD display with hour flashing. Adjust the hour by pressing SLEEP/HR/MIN button
on the unit continuously and press TIMER Button to confirm.
3. The minute flashes on the display. Set the minute by pressing SLEEP/HR/MIN button on the unit
continuously. Confirm your setting by pressing TIMER button. The timer “ON” shows on the display
to indicate the timer is activated (Press TIMER button again to disable the timer).
Note: When the hour or minute flashes on the display, the time can also be set by pressing HR
button or MIN button on the remote directly. After setting, press TIMER button to confirm.
4. The unit will be turned on automatically at the time you set for the timer.
FM RADIO
TUNING THE FM RADIO
1. Press STANDBY button to turn the unit on.
2. Press FUNCTION button on the unit repeatedly or press FM button on the remote to switch the unit
to FM mode.
3. Press TUNING+/- button to fine tune the radio station. Press and hold TUNING+/- button to
automatically tune the radio frequency forward and backward respectively. When an available station
is found, the unit will broadcast it immediately.
4. Press the PLAY/PAUSE button on the unit or ST/MO button on the remote to switch the radio
between MONO and STEREO.
5. Fully extend the telescopic antenna and adjust its direction for best radio reception.
SAVING FM RADIO STATIONS TO THE UNIT'S MEMORY
1. After tuning the FM radio to the desired stations, press MEM button, a number of a memory cell
flashes on the screen.
2. Press CHANNEL+/- button to select the radio memory cell.
3. Press MEM button again to save the current radio station to the selected memory cell. Up to 20 FM
radio stations can be saved.
4. To recall the preset station frequency, press CHANNEL+/- button repeatedly.
HANDLING AND MAINTENANCE OF A DISC
Follow the instructions below to handle and maintain your disc in order
that long time and trouble free performance can possibly be obtained:
Ensure not to caress the rain bow side of the disc; handle the disc by
the edge.
Long time exposure to sunshine, high temperatures and humidity will
damage the disc. And keep storage area clean.
Avoid sticking labels on both sides of a disc. Writing with pointed
articles on the disc should be strictly avoided.
Clean the disc wiping the centre and then working out to the edge
with a dry & soft cloth or a disc brush. Avoid any cleansing lotion or
chemical eradicator.
Store them in their cases when they are not to be used.
LOAD A DISC
1. Open the CD door by pressing the PUSH TO OPEN area.
2. Load a disc on the disc tray with the label side facing outside.
3. Close the CD door.
PLAY A DISC
1. Follow the instructions above to load a disc.
2. Press the FUNCTION button on the unit repeatedly or press CD button on the remote to switch the
unit to CD mode. "READING" shows on the screen to indicate the disc is being read.
3. When the disc is read successfully, playback will start from the first track.
HANDLE DISC ONLY AS SHOWN
CLEAN FROM CENTER TO EDGE
DO NOT STORE NEAR HEAT
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lenco BOOST-8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lenco BOOST-8 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 5,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info