585257
43
Zoom out
Zoom in
Previous page
1/89
Next page
Shutter speed priority - T
Setting the mode
1. Set the shutter speed dial (1.10) to the required value.
2. If necessary, press the click wheel (1.18) to set automatic
aperture control, i.e. in this case shutter speed priority mode.
The lens aperture is then controlled automatically based on the
available light and continuously between a fully open and mini-
mum aperture for the relevant lens.
Viewfinder and top panel display show
T (speed priority) for the selected exposure mode (2.5.c/3.8),
• the automatically set aperture value (2.6/3.11), and
• the manually set shutter speed value (2.8a/3.12)
Notes:
• If automatic sensitivity setting is activated at the same time
(see p. 30), the control range for shutter speed priority is
extended. Any maximum shutter speed set as part of the
automatic sensitivity setting does not override this.
• With very little light or extreme brightness, the available aper-
ture range of the lens you are using may no longer be suffi-
cient for the selected shutter speed. Set a different shutter
speed if possible. However, a correct exposure is normally
still used in such cases, by automatic setting of the appropri -
ate shutter speed, i.e. by “overriding” your manual selection.
may also appear to warn you that you are below the mete-
ring range (see p. 36). It is then no longer possible to correctly
meter the exposure.
Manual aperture and shutter speed setting - m
Setting the mode
1. Set the shutter speed dial (1.10) to the required value.
2. Press the click wheel (1.18) to set the aperture to manual
control.
3. Turn the click wheel to set the required aperture.
Viewfinder and top panel display show
m for the selected exposure mode (2.5.d/3.8),
• the manually set aperture (2.6/3.11) and shutter speed
values (2.8a/3.12), and
• a light balance (2.7), which assists in adjusting the exposure.
The light balance shows the deviation of the set shutter-
speed/aperture combination from the metered exposure value.
The display clearly shows the range ± 3 EV in
1
/
2
EV steps. Larg-
er deviations are shown with flashing of the outer markings on
the light balance scale. To achieve the correct exposure according
to the result of the exposure metering, the aperture and/or
shutter speed should be adjusted until the zero marking lights
up on the light balance.
Note:
If automatic sensitivity setting is activated at the same time
(see p. 30), the last manually set sensitivity is used. Any
maximum shutter speed set as part of the automatic sensitivity
setting has no effect.
The B setting
The B (bulb) setting keeps the shutter open as long as the shut-
ter release button remains pressed (maximum 32s).
In conjunction with the self-timer, an additional T function is
also available: If you set B and activate the self-timer by pres-
sing the shutter release button (see also p. 40), the shutter
opens automatically after the selected delay time. It then
remains open until you press the shutter release button a
second time – you do not need to hold the button down. This
enables you to largely prevent any blurring, even with long expo-
sures, by pressing the shutter release button. The exposure
meter remains off in both cases.
The viewfinder shows
(2.8c) instead of a shutter speed
The top panel display shows
• B (3.13), and
• after opening the shutter, the elapsed exposure time in
seconds (3.12)
Notes:
• Long exposure times can be associated with very heavy picture
noise. To reduce this annoying phenomenon, after pictures
with slow shutter speeds the LEICA S2 automatically takes a
second „black picture“ (taken with the shutter closed). The
noise present in this parallel picture is then digitally “subtrac-
ted” from the data set for the real picture.
• This doubling of the „exposure“ time can be significant in par-
ticular at longer exposures and must be considered. During
this time the camera should not be switched off.
• For shutter speeds of >
1
/
2
s the message Noise Reduction
appears in the monitor.
• Long time exposures using the B setting are produced using
only the focal plane shutter inside the camera, even if the
main switch (1.15) is set to CS (see p. 21).
Shutter speed priority / Manual mode / The B setting / 39
Inhalt_GB.qxp:Leica M8 deutsch 11.12.2009 10:24 Uhr Seite 39
FIRMWARE
UPDATE
FIRMWARE
UPDATE
FIRMWARE
UPDATE
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leica S2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leica S2 in the language / languages: English as an attachment in your email.

The manual is 2,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Leica S2

Leica S2 User Manual - German - 89 pages

Leica S2 User Manual - French - 89 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info