636417
11
Zoom out
Zoom in
Previous page
1/44
Next page
Rugby 410/420 DG 11Operation
Step 2 The X-Axis is automatically pre-selected as the axis to be precisely
aligned. Press the X/Y button to change to the Y-axis if desired.
During this process the cross-axis is automatically reset to 0.000%
grade.
The cross axis is at 0.000% grade when 'OK' is shown on the display.
On the second control point adjust the Rod-Eye receiver on the grade
rod and make sure it is located in the on-grade position on the axis
selected (solid bar or solid tone). This part of step 2 is very
important.
When you're done press STAR to continue.
Once STAR is pressed, the cross axis grade will change from 0.000% to
+5.000%.
As a result the laser beam signal on the receiver will most likely change
the elevation indication from the 'on-grade' position to either a 'high or
low' position. This is because the Rugby is not mechanically aligned and
the laser will no longer be giving an on grade signal. This is where the
electronic Axis Alignment is used.
Step 3 Carefully watch the arrows (laser beam) on the receiver.
•Use the UP / DOWN buttons to move the laser beam once again on
the center.
Select between Speed 1, 2 or 3 which is available in both directions.
One push will start moving the beam in slow speed.
A second push will move the beam at medium speed.
A third push will move the beam at highest speed.
During this process an arrow symbol is shown.
If the arrow symbol stops flashing the maximum limit is reached
and the laser beam does not move anymore. (If the laser beam did
not pass the 'on-grade' position on the receiver please consider
re-orientating the laser instrument).
To stop the laser beam movement press STAR.
If the Rod-Eye receiver shows an UP arrow displayed, use the
DOWN arrow on the remote control to return to 'on-grade'.
If the Rod-Eye receiver shows a DOWN arrow, then use the UP
arrow on the remote control to return to 'on-grade'.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leica Rugby 420DG at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leica Rugby 420DG in the language / languages: English as an attachment in your email.

The manual is 2,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info