695954
204
Zoom out
Zoom in
Previous page
1/261
Next page
EN
200
Picture mode
Manual setting
3. Set the level using the setting dial (30) - left = lower / right =
higher - or by pressing up/down on the direction pad (31). This
can also be done during the recording if you have previously
pressed the
INFO button (32). Level 0 means no sound
recording.
To prevent over-modulation, you should select the level at
which the peak value does not exceed the full modulation
marking at all, or only slightly/infrequently. This is illustrated
by the indicators being white above this marking and red below
it.
Note:
For mono recordings, both sides (= channels) in the bar chart run
parallel, or separately for stereo recording.
Even for stereo recordings, the level is not controlled separately for
each channel.
To reduce any noise caused by wind during the sound recording,
two levels of damping are available.
2. In the
Wind Elimination sub-menu, select Off, , Medium or High.
Whenever no wind noise is feared, you should select
Off to
ensure optimum sound.
TAKING PHOTOGRAPHS WITH THE SELF-TIMER
You can use the self-timer to take a picture with a delay of either 2
or 12s. This can be particularly useful, for example in the first case
if you want to avoid the picture being out of focus due to camera
shake when releasing the shutter or, in the second case, for group
photographs where you want to appear in the picture yourself.
Setting and using the function
1. Turn the main switch (16) to
.
2. In the main camera menu, (see p. 154/248) select
Self-timer (page 1, CAMERA section), and
3. select the required delay time in the associated sub-menu.
4. To start the delay time, press the shutter release button (17) to
the 2nd pressure point (see p. 151).
The LED (7) on the front of the camera flashes for the first
10s of a 12s delay time to show the progress of the delay
time. The countdown is shown in the monitor at the same
time.
While the self-timer delay time is running, it can be canceled at any
time by pressing the
SET or MENU button - the relevant setting is
retained and the function can be restarted by pressing one of the
shutter release buttons again.
Important:
In self-timer mode, the exposure is not set by pressing the shutter
release button to the pressure point, it is set immediately before
the picture is taken.
204


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leica M-E - 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leica M-E - 240 in the language / languages: English, German as an attachment in your email.

The manual is 8,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Leica M-E - 240

Leica M-E - 240 User Manual - Dutch, French - 261 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info