1414
Now continue as described for rough correction
with standard mounting.
b. Extending the elevation turret correction range
1. Set the elevation turret to its default delivery
condition (locked, scale value "5" (50 clicks)).
2. Loosen the clamping screws (1.a).
3. Lift the top knurled dial (1) inc. scale ring (3)
until it is no longer engaged.
4. Now turn the top knurled dial (1) inc. scale ring
(3) until it provides you with an additional
adjustment range.
(For example: The number of clicks from the "5"
position to the mechanical stop at "0" is not
sufficient for zeroing. You turn the top knurled
dial to the "7" position. You have thus gained
20cm of adjustment towards "0".)
5. Now press the top knurled dial (1) right down
and hold it in place.
6. Securely tighten the clamping screws (1.a)
Note:
Extending the adjustment range for zeroing can
result in a restricted adjustment range in actual use /
when correcting the point of impact. If necessary,
use a pre-tilted mounting as described under a) to
achieve optimum results.