532121
56
Zoom out
Zoom in
Previous page
1/74
Next page
3D Disto, Software Applications
56
A lower tolerance increases the accuracy of your measurements and requires
precise aiming and visibility of the Secure Points.
If there are no Secure Points available but your measurement must fit to the
geometry of a previous one, just start your measurement with the same Base
Line points. These are the first two points of a measurement.
3.
If Secure Points are available, folder opens.
Choose a Secure Point by pressing / or by tapping on the screen.
Press to enlarge.
Press to see all Secure Points of the whole memory.
4.
Press to confirm point.
Pointfinder opens.
5. Target the target mark shown in the photo as precisely as possible and press
to measure.
If successful, pop-up appears Measure next Secure Point? Yes/Cancel.
6. If Yes: Folder opens to choose next Secure Point.
Proceed as described previously for the second and third Secure Point.
If the first two Secure Points were measured successfully the 3D Disto
roughly turns to the next chosen Secure Point. You just have to do the fine
targeting and press .
7. When you have measured three points successfully a pow-up shows OK.
Measure more Secure Points? Yes/No/Cancel.
Press Yes to continue and proceed as described previously.
Press No to finish.
If successful, a pop-up displays the dimensions between old and new posi-
tion: XXXm; Height: XXXm; OK/Cancel. Accept with OK or Cancel to
measure further points.
If Relocation was not successful, pop-up prompts Out of tolerance!
Measure more Secure Points? Yes/No/Cancel. Go on as described previ-
ously.
8.
Press to close the application.
Step Description
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leica 3D Disto at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leica 3D Disto in the language / languages: English as an attachment in your email.

The manual is 4,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Leica 3D Disto

Leica 3D Disto User Manual - German - 214 pages

Leica 3D Disto User Manual - Dutch - 220 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info