534693
83
Zoom out
Zoom in
Previous page
1/104
Next page
Manual Leapfrog Creatr
83 Leapfrog BV
4.9 Calibrating the heated printbed
To calibrate your heated bed bring your bed to the Z-home postion and make sure that your
nozzles are at the same height. If they are not, please check paragraph 3.6 to level the extruders.
To make sure that your heated printbed is correctly calibrated again you need to send the nozzles
to the four corners of your heated printbed using the X-/+ and Y-/+ buttons.
In each corner you need to see the same distance between the nozzles and the heated bed. You
can adjust this by (un)screwing the bolts that hold the bed in the corner a little as shown in the
picture below. Once the distance is the same at every corner check the z-offset as explained in
par. 3.2 and you are ready to print.
83


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leapfrog Creatr at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leapfrog Creatr in the language / languages: English as an attachment in your email.

The manual is 8,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info