534693
77
Zoom out
Zoom in
Previous page
1/104
Next page
Manual Leapfrog Creatr
77 Leapfrog BV
4.6 My extruders are not the same height
When there is a height difference between the extruders, support material will not properly attach to the
printed part or will melt into the printed part. This guide will explain how to level both extruders to the
same height.
Loosening the index bolt
The index bolt can be found when you look through the fans on the extruder carriage as
indicated on the picture. Use an Allen wrench to loosen the index bolts of both extruders. It is
not necessary to take them out, only loosen them
Sliding the hot end down
After loosening the index bolts, the hot ends will be able to slide up and down. Use pliers to
move the hot end which is a little bit too high downwards.
The next step is to home the Z-axis by pressing Z-home Manual control” tab. The other
hot end will start to move upwards. At this moment in time, both your hot ends are positioned
on the same height.
Make sure you tighten the index bolts of both extruders to secure their position.
77


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leapfrog Creatr at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leapfrog Creatr in the language / languages: English as an attachment in your email.

The manual is 8,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info