534693
73
Zoom out
Zoom in
Previous page
1/104
Next page
Manual Leapfrog Creatr
73 Leapfrog BV
4.5 Nozzle seems clogged
In most cases the problem can be resolved by increasing the temperature by 10 degrees and extruding.
Please follow the steps as described below.
Retract the filament.
Manual Control” tab select the extruder of which the nozzle is clogged. Make sure
RetractRetract
upwards]. Retract until the filament is retracted from the nozzle and remove the filament in an
upward direction from the extruder.
Increase the extruder temperature by 10 degrees.
Increase the temperature of the extruder that is clogged [Extruder 1 or Extruder 2] as shown in
Heat extruder”.
Snip of the used filament, and make sure the cut is perpendicular to the direction of the filament.
73


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Leapfrog Creatr at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Leapfrog Creatr in the language / languages: English as an attachment in your email.

The manual is 8,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info