777993

Laurastar Lift Plus Manual

6
Zoom out
Zoom in
Previous page
1/82
Next page
- 7 - - 8 -
Maintenance
WARNING: The appliance should be UNPLUGGED, OFF
and COLD before cleaning the appliance. Switch off
and unplug the appliance from the outlet. Allow your
appliance to cool down for at least 2 hours. It is preferable to
clean the appliance BEFORE use.
NOTICE! Only rinse the appliance with water. NEVER use
descaling products or other chemical products.
Cleaning the iron
If the iron’s soleplate is dirty, use our soleplate cleaning mat in accordance
with the instructions. This can be obtained at www.laurastar.com or from
your approved Laurastar retailer. A
Stubborn stains can be cleaned using an abrasive dishwashing sponge.
After having completed this operation, remove the aluminium oxide
present under the soleplate by cleaning it with a damp cloth. B C
Indicator light for changing the lter cartridge (8)
A red indicator light signals that the lter cartridge needs to be changed
(17).
Please drain the appliance at the same time.
Changing the lter cartridge (17)
• Lift the cover of the water reservoir and remove the reservoir by pulling
on the cover. Drain the water and remove the lter cartridge (17). D
• Insert a new lter cartridge (17) (available at www.laurastar.com or
from an approved Laurastar retailer) and ll the water reservoir. E
• Finally, validate the change by pressing the change cartridge switch (8).
Filling
• To remove the protective soleplate (10), pull on the tab and remove the
iron while it is still hot. E
WARNING: The protective soleplate and the iron are hot!
Use caution when you remove the protective soleplate.
NOTICE: ALWAYS remove the protective soleplate after use.
Advice
For mohair, cashmere, velvet, angora: do not allow the fabric to make
contact with the protective soleplate (10). Iron the fabric at a distance of
approximately 10 cm / 4 in while diffusing steam, so that the fabric does
not become felted. Then take the item of clothing in your hand and shake
it to restore its volume. F
For velvet, corduroy and jersey, we recommend steaming without the
protective soleplate (10) at around 2-3 cm / 1-2 in from the fabric, then
levelling out by hand.
Vertical smoothing out
Suspend the item of clothing on a hanger. Moving the appliance from the
top to the bottom, lightly touch the fabric with the appliance outputting
small jets of steam. Note: Almost all fabrics smooth out easily, with
the exception of cotton, linen and certain silks. If a fabric is difcult to
smooth out, place it on the ironing board and iron it normally. G
WARNING: Do not iron or vertical steam clothes that are
being worn. Do not use vertical steam in the direction of
people or pets.
10 cm
Low water indicator light (9) and audible alarm
A warning tone sounds and a red indicator light lights up to signal that
there is no water left in the reservoir (4).
You can ll the reservoir without rst switching off your appliance.
To ll the reservoir (4)
• Lift the cover of the water reservoir and remove the reservoir by pulling
on the cover. Fill it with water from the tap. A
• Replace the reservoir (4) with the cover raised, then close the cover.
A
B
C
E D
E
F
G
A
EN
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laurastar Lift Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laurastar Lift Plus in the language / languages: English, German, Dutch, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 69.01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Laurastar Lift Plus

Laurastar Lift Plus Quick start guide - English - 16 pages

Laurastar Lift Plus Quick start guide - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info