Manual Laserliner MultiBeam-Laser MBL 3 (page 10 of 40) (English, German, Dutch, Danish, French, Italian, Polish, Spanish, Finnish)

646769

Zoom out

Zoom in

1/40

Position the unit at the height of point a1 as close to

the wall as possible and adjust the unit in the Xaxis.

4 Turn the device through 180° and mark point A3. The

difference between points A2 and A3 is the tolerance

for the X axis (P. 9).

5 If points A2 and A3 are more than 2 mm / 10 m apart

the device is in need of calibration. Remove cover for

laser calibration and adjust laser to point A2 using

enclosed

allen wrench.

6 Mark point D and switch unit on. Project plumb of D

to ceiling and mark point E. Turn unit 180 ° and

project again from D to ceiling and mark point F. The

difference between E and F is the tolerance for the

Z-axis.

7 Should E and F be more as 4 mm / 10 m apart the

plumb laser must be calibrated. Remove cover for

calibrating and adjust laser between point E and

point F.

Preparing the calibration check

It is possible for you to check the calibration of the laser. To do this, position the device midway between 2

walls, which must be at least 5 metre apart. Switch the

device on. The best calibration results are achieved if the

device is mounted on a tripod.

1 Mark point A1 on the wall.

2 Turn the device through 180° and mark point A2.

You now have a horizontal reference between points

A1 and A2.

ENGLISH10

MultiBeam-Laser MBL 3

180°

2 mm / 10 m = OK

EFFE

min. 5 m

Performing the calibration check

3 Position the device as near as possible to the wall at the height of point A1. Adjust the device in the

X axis.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner MultiBeam-Laser MBL 3 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish, Finnish as an attachment in your email.

The manual is 1,02 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Laserliner MultiBeam-Laser MBL 3 Manual

Product: