646726

Laserliner DigiLevel Plus Manual

7
Zoom out
Zoom in
Previous page
1/52
Next page
DigiLevel Plus
07
2
3
1
4
Switching on and measuring
The DigiLevel Plus can measure angles continuously
to 360°.
– Switch the DigiLevel Plus on using the on/off switch (4).
– The slope angle is shown in the display (8). If slopes
are measured overhead, the direction of display
adjusts automatically.
– The current slope direction is also shown by
the symbol (7).
Selection of unit of measurement
Button (5) allows the desired unit of measurement to be
selected (° degrees, %, mm/m).
Inserting batteries
Open the battery com-
partment and insert
batteries according
to the symbols. Be
sure to pay attention
to polarity.
Calibration
1. Place the measuring face (17) on an even surface with
position mark (see Fig. below). Switch on device (4) and
keep the CAL button (3) pressed until CAL 1 appears
on the display.
2. Press the CAL button (3) again. CAL 1 ashes. The
display then switches to CAL 2 and a signal sounds.
3. Now turn the spirit level vertically by 180° and
place exactly on the marked surface (reverse
measurement).
4. Press the CAL button (3) again until CAL 2 ashes.
The subsequent acoustic signal concludes the process.
The unit is properly calibrated when it displays
the same measurement value, i.e. the underlying
surface‘s deviation from absolute level, in both
positions (0° and 180°).
!
Make sure that the reference function
is deactivated before measuring.
!
GB
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner DigiLevel Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner DigiLevel Plus in the language / languages: All languages as an attachment in your email.

The manual is 3,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info