646113

Laserliner CableTracer Pro Manual

20
Zoom out
Zoom in
Previous page
1/312
Next page
4
Sender TX: Set sender code
If you are using only one sender, it is not necessary to adjust the sender code. If you are using more than
one sender, the sender code must be adjusted. To do this, ensure that the device is turned off. Then hold
down the sender code button (4) and brie× y press the ON/OFF button (5). Then press the sender code
button and set the desired code. Set all devices in use to different sender codes. The ON/OFF button then
saves the settings and switches the device on. There are 7 sender codes to choose from.
45
simultaneous
HOLD
CODE
LEVEL
LEVEL
LEVEL
LEVEL
CODE
LEVEL
CODE
LEVEL
Connect the cables to the device. Ensure that the proper polarity is observed when doing so! Use the ON/
OFF button (5) to switch the device on. Depending on the application, the output power of the signal can
be selected using the sender code button (4): level 1 = lowest power; level 3 = highest power. Increasing
the power from lowest to highest expands the operating distance of the receiver RECV by Ö ve times. If
external voltage is present, the LC display indicates the magnitude of the voltage and the warning symbol
(B). It also shows the sender code. To illuminate the display, press the sender code button (4) and hold it
down for 2 seconds. To switch the device off, press the ON/OFF button and hold it down for 2 seconds.
The device can be operated with or without voltage and is voltage-resistant up to 400 V.
Sender TX: Set-up
3
- Be sure to observe the safety instructions when working with live cables.
- The integrated external voltage warning (B) of the sender must not replace checking for zero
voltage!
!
5
4B11 97
12 108
20
GB
Manual_CableTracer-Pro_Rev.0710_GB.indd 020 02.09.2010 11:28:14 Uhr
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner CableTracer Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner CableTracer Pro in the language / languages: All languages as an attachment in your email.

The manual is 4,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info