680944

Lancom L-11 Manual

52
Zoom out
Zoom in
Previous page
1/102
Next page
Operating modes and functions
|
|
LANCOM Wireless L-11/IL-11
|
52
EN
4.1.4 Point-to-point network
On a point-to-point network, two or more access points communicate with
each other. When configuring mobile stations, proceed exactly as you would
for setting up an infrastructure network. It is also possible to connect point-
to-point networks and infrastructure networks.
For the access points in this case, however, both the network name and the
radio frequency have to be the same and interpoint communication has to be
enabled. Furthermore, in the list of protocols you can only define the proto-
cols that are copied in the network. You can increase data throughput by
excluding any unneeded protocols.
The corresponding menu commands are as follows:
WEBconfig:
Advanced configuration / Setup / WLAN module
LANconfig:
/ Management / Interfaces
/ WLAN access / General / Point-to-point
4.1.5 Wireless Internet gateway via ISDN (LANCOM Wireless
IL-11)
For a wireless Internet gateway via ISDN, proceed on the client side exactly
as you would for setting up an infrastructure network.
Only a few steps are required to set up Internet access for all network users
via the integrated ISDN router. The easiest method to set up Internet access
is by using the setup wizard provided in Webconfig or LANconfig. You can
then fine-tune the settings manually in the individual router tables:
• Layer list
The layer list contains predefined protocols, which you can customize as
needed (e.g. for channel bundling). The standard protocol is PPPHDLC,
which you can use in most cases. Here, assign a layer name for the ISDN
gateway. That defines it for the Internet connection to be configured.
• Name list
Data for remote stations and the phone numbers. Here, for example, en-
ter the Internet provider you call for an ISDN connection. The recom-
mended idle time is about 90 seconds. Apply the layer names that you
have created in the layer list.
… 52 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lancom L-11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lancom L-11 in the language / languages: English as an attachment in your email.

The manual is 3,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lancom L-11

Lancom L-11 User Manual - German - 106 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info