680930
71
Zoom out
Zoom in
Previous page
1/80
Next page
LANCOM 800+ – LANCOM DSL/I- 10+ – LANCOM DSL/I- 1611 Office
Chapter 9: Troubleshooting
71
EN
9Troubleshooting
In this chapter, you will find suggestions and assistance for a few common dif-
ficulties.
9.1 No WAN connection is established
After start-up the router automatically attempts to connect to the access pro-
vider. During this process, the Online LED will blink green. If successful, the
LED will switch over to steady green. If, however, the connection can't be
established, the Online LED will light up red.
For LANCOM 800+ and LANCOM DSL/I-10+only. For LANCOM DSL/I-
1611 Office please refer to the LED description (’LEDs for LANCOM
DSL/I-1611 Office’ page 22).
The reason for this is usually one of the following:
Problems with the cabling?
Only the cable provided with your device should be used to connect to the
WAN. This cable must be connected to the Ethernet port of your broadband
access device. The WAN link LED must light green indicating the physical con-
nection.
Has the correct transfer protocol been selected?
The transfer protocol is set along with the basic settings. The basic setup wiz-
ard will enter the correct settings for numerous DSL providers automatically.
Only if your DSL provider is not listed, you will have to enter manually the pro-
tocol being used. In any case, the protocol that your DSL provider supplies you
with should definitely work.
You can monitor and correct the protocol settings under:
Configuration tool Run command
LANconfig Management Interfaces Interface settings WAN Inter-
face
WEBconfig Expert Configuration Setup Interfaces WAN Interface
71


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lancom DSL-I 1611 Office at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lancom DSL-I 1611 Office in the language / languages: English as an attachment in your email.

The manual is 1,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lancom DSL-I 1611 Office

Lancom DSL-I 1611 Office User Manual - German - 83 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info