729366
110
Zoom out
Zoom in
Previous page
1/122
Next page
LANCOM 1722 VoIP – LANCOM 1723 VoIP – LANCOM 1724 VoIP – LANCOM 1823 VoIP
Chapter 13: Troubleshooting
110
EN
13 Troubleshooting
In this chapter, you will find suggestions and assistance for a few common dif-
ficulties.
13.1 No DSL connection is established
After start-up the router automatically attempts to connect to the DSL pro-
vider. During this process, the LAN-link LED will blink green. If successful, the
LED will switch over to steady green. If, however, the connection can't be
established, the LAN-link LED will light up red. The reason for this is usually
one of the following:
Problems with the cabling?
Only the cable provided with your device should be used to connect to DSL.
This cable must be connected to the Ethernet port of your broadband access
device. The LAN link LED must light green indicating the physical connection.
Has the correct transfer protocol been selected?
The transfer protocol is set along with the basic settings. The basic setup wiz-
ard will enter the correct settings for numerous DSL providers automatically.
Only if your DSL provider is not listed, you will have to enter manually the pro-
tocol being used. In any case, the protocol that your DSL provider supplies you
with should definitely work.
You can monitor and correct the protocol settings under:
13.2 DSL data transfer is slow
The data transfer rate of an broadband (Internet) DSL connection is dependent
upon numerous factors, most of which are outside of one's own sphere of
influence. Important factors aside from the bandwidth of one's own Internet
connection are the Internet connection and current load of the desired target.
Numerous other factors involving the Internet itself can also influence the
transfer rate.
Configuration tool Run command
LANconfig Management Interfaces Interface settings WAN Inter-
face
WEBconfig Expert Configuration Setup Interfaces WAN Interface
110


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lancom 1722 VoIP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lancom 1722 VoIP in the language / languages: English as an attachment in your email.

The manual is 2,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info