Manual Laica VT3118 (page 7 of 36) (English, German, French, Italian, Portuguese, Spanish)

677547

Zoom out

Zoom in

1/36

12 13

5. “SEAL” key: when this key is pressed:

• the appliance begins sealing;

• air extraction stops and the bag is automatically sealed.

6. "STOP" key: if the machine is running when this key is pressed, the

previously selected function will be blocked.

7. “CANISTER” key: when this key is pressed, the vacuum cycle for the

canisters (not supplied) begins.

8. “MARINATE” key: when this key is pressed, the speciﬁc quick marinating

cycle begins.

9. Lights: indicate the operations in progress and the selected functions.

10. Sealing bar: seals the bag.

11. Gaskets: create the necessary seal in the vacuum chamber in order to

generate a vacuum in the bags.

12.13. Vacuum chamber and liquid tray: area where the far open end of the

bag is positioned to allow air extraction and the elimination of any excess

liquids.

14. Sealing gasket: guarantees the bag's adherence to the seal bar.

16.17. Two-way cutter: cuts the roll into bags in the desired size.

18.19. Socket for container tube: connects the machine to the canisters

through the supplied tube.

20. Locking latches: lock the lid to the base of the machine.

21. Lid opening keys: releases the lid.

TECHNICAL DATA

- Voltage: AC 220-240V 50Hz

- Power absorption: 120W

- Vacuum value (approx): -0.8 bar

- Environmental operating conditions: +10°C +40°C; relative humidity ≤85%

- Environmental storage conditions: +10°C +50°C; relative humidity ≤RH 85%

- MAX bag width: 300 mm

The supplied rolls are for food

INSTRUCTIONS FOR USE

PREPARATION

• Before each use, carefully clean the appliance as described in the

"Maintenance" section.

• Place the device on a ﬂat, hard surface, taking care to leave the work area

in front of the appliance free from obstacles and wide enough to enable the

support of the bags with the food to be packaged.

• Connect the appliance to a power outlet and verify that the indicator lights of

the "Normal" and "Dry" functions come on.

• Distribute the food to preserve evenly within the bag. Make sure the bag

length is 8 cm longer than the food to be preserved.

• Lift the lid.

You can select the air extraction power and the sealing time of the

appliance according to the food that you're packaging (see the "Description

of Functions" section). The machine is automatically set in the function

"VACUUM-NORMAL" and "FOOD-DRY ".

After changing the selection of the air extraction power and the sealing time,

it remains in the memory until the appliance is disconnected from the power

outlet.

USE WITH BAGS

1. Position the open end of the bag inside the vacuum chamber as shown in

ﬁgure 2.without covering the air suction hole.

For Laica bag codes VT3500, VT3501, VT3502, VT3503 and VT3504 and

Laica roll codes VT3505, VT3508 and VT3509, position the bag with the

smooth part facing down.

Make sure the sealing point, inside the bag, is clean and free of any food

particles.

The bag must be perfectly stretched and without any creases.

2. Lower the lid and press ﬁrmly with both hands on the sides of the same,

engaging the locking levers on the base until you hear a "click".

3. Press the “AUTOMATIC” key to start the automatic vacuum and sealing

process. During the extraction of air the "AUTOMATIC" key lights up, while

during sealing the "SEAL" key lights up.

4. Wait until the "SEAL" key goes out. Press the two keys for lid opening and lift

the lid.

5. Check that the bag is properly sealed and place it in the refrigerator, freezer

or pantry.

USE WITH ROLLS

Using the roll, it is possible to prepare bags in the desired length speciﬁc to the

type of food being stored.

1. Lift the lid.

2. Move the cutter completely to the right or left of its support, then lift the

support and pass the end of the roll underneath it.

Determine the bag length based on the length of the food being stored and

add at least 8 cm.

3. Lower the cutter support and cut the roll by sliding the cutter.

4. Place one of the two open ends of the bag on the sealing gasket. For Laica

roll codes VT3505, VT3508 and VT3509, place the smooth side facing

down.

5. The bag must not protrude from the vacuum chamber and liquid tray or on

the gasket seal.

6. Make sure that the bag is fully stretched out, clean and without any creases.

7. Lower the lid and press ﬁrmly with both hands on the sides of the same,

engaging the locking levers on the base until you hear a "click."

8. Press the “SEAL” key to start sealing. When the “SEAL” key turns off, sealing

is complete.

9. Press the two keys for lid opening and lift the lid.

10. Check that the bag is properly sealed.

11. Continue as described in the "PREPARATION" and "OPERATING

INSTRUCTIONS - USE WITH BAGS" sections.

MANUAL VACUUM

Total air extraction using the automatic method tends to crush and damage

foods with a more delicate and fragile consistency (such as strawberries, berries,

breadsticks, vegetables, etc.); in these cases, it is therefore possible to use the

manual vacuum function, interrupting air extraction when necessary.

1) Position the bag and hook the machine lid as described in points 1 and 2 of

the “Use with bags” section.

2) Press the “AUTOMATIC” key to start air extraction. Carefully watch the air

being extracted from the bag, and when necessary, stop the vacuum process

by pressing the “SEAL” key.

When the “SEAL” key turns off, sealing is complete.

3) Lift the lid and check that the bag is properly sealed.

USE WITH CANISTERS (not supplied)

Only use Laica canisters, code VT3304.

To generate a vacuum in canisters, the machine’s vacuum power level must be

set to “VACUUM-NORMAL”.

Prior to use, make sure the lid, canister and gasket are completely clean and dry.

1) Fill the canister up to a maximum of 3 cm below the top edge.

2) Put on the lid and rotate the relief valve of the lid to the "•SEAL" position.

3) Connect the container tube by inserting one of the two ends into the socket

located on the right side of the machine, and the other end into the socket

located on the canister lid.

4) Press the “CANISTER” key to start the automatic vacuum process. During the

air extraction the "CANISTER" key lights up. Wait until the light on the key

goes out.

5) Extract the tube from the canister, taking care not to rotate the relief valve and

then extract it from the machine, then put it in the fridge, freezer or pantry.

“Quick marinate” function in the canister (not supplied)

This function reduces the amount of time required to marinate food through 15

cycles, which alternate the extraction and release of the air inside the canister.

1) Fill the canister and connect it to the machine as described above.

2) Set the machine vacuum power according to the food being marinated (see

the “Description of Functions” section).

3) Press the "MARINATE" key to start the automatic air extraction procedure and

the release of the air.

During this operation, the key lights up. The quick marinate process takes

English English

EN EN

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Laica VT3118 in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,64 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Laica VT3118 Manual

Product: