Manual Laica VT3113 (page 10 of 22) (English, German, French, Italian, Spanish)

677550

Zoom out

Zoom in

1/22

20 21

Instructions and warranty

English

VACUUM PACKAGING MACHINE

YOU ARE STRONGLY RECOMMENDED TO READ THE INSTRUCTIONS

AND WARNINGS HEREIN BEFORE USING THE EQUIPMENT AND

TO KEEP THE BOOKLET IN A SAFE PLACE.

IMPORTANT WARNINGS

Using any electrical appliance entails compliance with a number of

fundamental rules:

• Unplug the appliance from the mains straight after use and before

commencing cleaning or inserting/removing accessories.

• Do not touch the sealing strip when the device is switched

on, in order to avoid possible burnings.

• Do not unplug by tugging on either power cord or appliance.

• If an electrical appliance falls into the water, do not attempt to retrieve it;

instead, unplug immediately.

• Never immerse the appliance in water or other liquids.

• Never leave the appliance working unattended, and never allow it to be

used by children, handicapped or disabled individuals.

• This appliance may only be used by children aged from 14 years.

• This appliance may only be used by persons with reduced physical,

sensory or mental capabilities or by inexperienced persons if previously

instructed on the use in conditions of safety and only if informed on the

dangers related to the product itself.

Children must not be permitted to play with the appliance. Cleaning

and maintenance may not be performed by children without adult

supervision.

• Children must be supervised to ensure that they do not play with the

appliance.

• This appliance must be used solely for the purpose for which it was

designed and in accordance with the operating instructions.

Any other use shall be considered improper and hence hazardous.

The manufacturer cannot be held responsible for any damage resulting

from improper or incorrect use.

• Before using the appliance, make sure it is intact and does not feature

any visible signs of damage. If in any doubt, do not use the appliance

and contact your dealer.

• In the event of a fault and/or irregular operation, turn the appliance off

at once without tampering with it.

Always contact your dealer for repairs.

• Keep the appliance away from sources of heat.

• Make sure to have dry hands when inserting and removing the plug and

when the device is used.

• Never use adapters for power supply voltages differing from the rating

data located on the label located on the bottom of the device.

Keep the cable away from hot surfaces.

• Attention! Do not handle the electric wire for any reason.

For any damage, please consult your retailer.

• The shell of this device is not protected against the penetration of

liquids.

• Under extreme conditions of use (voltage being 10% more than the

rated voltage and temperature around 40°C), the intensive use of the

device may require the triggering of automatic devices for thermal

protection. In this case, await until the device cools down, before using

it again.

Do not perform any vacuum packaging cycle for more than

40 times consecutively; besides this limit, the automatic

systems for the thermal protection of the device may trigger.

In this case, await about 20 minutes for the restoration of

these protection systems (We suggest to await at least 2

minutes between one sealing and the following one).

• Use only original bags of the manufacturer.

NOMENCLATURE AND FUNCTIONS

1 O/I KEY by pressing this key:

• the device creates the vacuum and seals the bags automatically.

• the device seals (bag sealing function), in case rolls are used.

• air suction is stopped and the bag is sealed automatically.

2 ON/OFF WARNING LIGHT: If the warning light is switched off, it

means that the device is switched off.

If the warning light is not so bright, it means that the device is switched

on (plug connected to the outlet); while if it is bright, it means that the

device is operating.

3 SEALING BAR: It performs the hot sealing.

4 SUCTION CHAMBER: Area in which the open end of the bag is

positioned to allow the air suction.

5 ROLL COMPARTMENT

6 GASKET / SILICONE SEAL: It creates an optimal seal in the suction

chamber in order to create the vacuum in the bags.

7 CUTTER: It is used to cut the roll and obtain a bag of the wished length.

8 COVER: It creates the tightness necessary to create the vacuum in the

bag.

9 SEALING GASKET: It assures the adherence of the bag on the sealing

rod.

10 EXHAUST VALVE: It releases the cover after air suction and bags

sealing.

11 LOCKING LEVERS

INSTRUCTIONS FOR USE

After hooking the cover and before pressing the keys for the

sealing and/or vacuum process, it is necessary to press with a

hand slightly on the cover and then with the other hand to select

the wished function. The device starts the operation cycle.

After some seconds, remove the hand from the cover.

USE OF THE BAGS

1) Before each use, clean carefully the device following the instructions

given in paragraph “Cleaning and maintenance”.

2) Place the device on a flat and stiff surface and leave the working area in

front of the device free of hindrances, as well as enough space to allow

the leaning of the bags with the food to be packaged.

3) Connect the device to a power supply outlet corresponding to the rating

data given on the bottom of the device.

Verify that the ON/OFF warning light is lighted (less bright).

4) Verify that the length of the bag is about 8 cm longer than the food to be

preserved.

5) Insert homogenously the food to be preserved in the bag.

6) Lift the cover.

7) Position the open end of the bag within the suction chamber as shown

in figure 2 with the smooth part upward.

Make sure that the inner part of the bag in the point where the sealing

will be performed is both clean and free from any food particles. It has

to be well stretched and without wrinkles.

8) Firmly press with one hand on one of the cover sides and with the other

hand hook the locking lever. Repeat the operation, to hook the lever on

the other side of the cover.

9) Now the cover is closed.

Press the key “O/I” to start the operation cycle and wait; sequentially

and automatically air suction starts; when the device has reached the

maximum vacuum level, the suctions stops and the sealing starts (ON/

OFF warning light on, full brightness).

Now the cycle has been completed; wait for few seconds, slightly lift

one side of the exhaust valve positioned on the cover (caution: Do not

pull the valve too much to prevent it from being removed from the cover

itself) and release the locking levers by pressing firmly on both sides of

the cover (until you hear a “click”).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Laica VT3113 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Laica VT3113 Manual

Product: