Manual Laica TH1001 (page 9 of 44) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

655545

Zoom out

Zoom in

1/44

INFRARED FOREHEAD THERMOMETER

The variation can be between 0.2 - 1° C.

Temperatures measured with different thermometers cannot be compared

with one another. Tell your doctor or take into account when diagnosing

yourself what thermometer you used in what part of the body to measure the

temperature.

INSERTING/REPLACING THE BATTERY

The battery has to be urgently replaced when on the display the symbol of

"discharged battery" appears.Before replacing the battery, switch off the

thermometer to avoid damaging the mechanism.

1) extract the screw from the cover of the battery compartment.

2) open the cover and remove the battery

3) insert the new battery and place the positive pole upwards.

4) place the cover back on the battery compartment.

5) screw the screw in the cover.

Extract the batteries and dispose them as special waste at the specific collection

points forecast for recycling. For more information about the disposal of run

down batteries, please contact either the store where the device containing

the batteries was purchased, or the Municipality, or the waste disposal local

service.

Caution: For greater safety, children younger than 12 years

shouldnot remove the batteries.

INSTRUCTIONS FOR A CORRECT USE

MEASUREMENT OF THE FOREHEAD TEMPERATURE (HEAD)

1) Make sure that the probe is clean and integral.

2) Clean the temple where the probe will lean.

3) Switch on the thermometer, by pressing the key “ON/MEM”.

On the display appear all the function symbols (self-test); after few

seconds, the display shows the message “HEAD-°C” and emits two beeps.

At this point, the thermometer is ready for use.

4) Lean the probe on the right or left temple; press the key SCAN and keep it

pressed, then slowly move the probe around the temple. The thermometer

emits beeps indicating that the measurement is taking place.

5) A longer and more intense acoustic signal indicates that the measurement

has ended (Time necessary to perform the measurement ranges from 5 to

30 second according to the temperature of the person).

Should the temperature exceed 37.5°C, the thermometer emits a long beep

followed by other three shorter beeps.

6) Release the key SCAN and then detach the probe from the temple; read the

measured value on the display

Important: the temperature shown on the display is equal to the oral

temperature, i.e. temperature measured on the forehead is translated as if

it were measured in the mouth.

7) The device switches off automatically after 1 minute, if it is not used.

MEASUREMENT OF THE ROOM TEMPERATURE ( )

This thermometer allows the measurement of the room temperature.

1) Switch on the thermometer, by pressing the key “ON/MEM”. On the display

appear all the function symbols (self-test); after few seconds, the display

shows the message “HEAD-°C” and emits two beeps.

2) Keep the key “ON/MEM” pressed and then press the key SCAN.

English

The display shows the icon “ ” (HEAD disappears).

3) If you wish to measure the temperature on a precise point, press the key

SCAN.

The thermometer measures the temperature in 0.6 seconds.

If the SCAN key is kept pressed, temperature is updated continuously.

4) The device switches off automatically after 1 minute, if it is not used.

When it is switched on again, the display shows the forehead temperature

measurement function (HEAD).

CELSIUS/FAHRENHEIT

This thermometer can measure temperature both in Celsius and Fahrenheit

degrees.

Each time you wish to change the measurement unit, proceed as follows:

1) With switched off thermometer, keep the key SCAN pressed without

releasing it for some seconds, and then press contemporaneously the key

ON/MEM until the displays shows °F (or °C).

2) The thermometer emits two beeps; at this point, release the key SCAN and

the key ON/MEM.

Now the measurement unit has been changed.

Proceed with the measurement according to paragraph “INSTRUCTIONS FOR

A CORRECT USE”.

MEMORY FUNCTION

This device stores in memory the last 25 measurements performed to evaluate

eventual variations. The measurements are stored automatically after that the

thermometer has switched off.

Only forehead temperatures (HEAD) included between 22°C and 42.2°C

(71.6°F and 108.0 °F) are stored.

After the first 25 measurements, the oldest data are erased automatically.

To call up saved measurements, switch on the thermometer, and press the

key ON/MEM (Every time the key is pressed, saved data are scrolled). On

the upper part of the display appears the symbol “M” and before each stored

data appears the corresponding number (1= most recent measurement - 25

oldest measurement).

The stored measurements are displayed for about 1 minute.

After about 1 minute from releasing the ON/MEM key, the device switches

off automatically.

CLEANING AND MAINTENANCE

Before and/or after each use, clean the probe of the thermometer with a soft

cotton cloth moistened with water or alcohol to assure accurate measurements

and to avoid microbial contaminations.

The probe is the most delicate part of the thermometer; pay utmost care during

the cleaning.

Let the probe dry completely for about 30 minutes.

The thermometer body has to be cleaned with a soft and dry cloth.

THE BODY OF THE THERMOMETER HAS NOT TO BE WASHED WITH

WATER.

Absolutely neither use abrasive products, nor plunge the thermometer in

water or other liquids.

Store the thermometer in a dry and clean place away from direct sunlight.

Instructions and guarantee

English

WWW.LAICAHEALTHCARE.RO

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Laica TH1001 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 3,92 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Laica TH1001 Manual

Product: