【2】
S
Gas oven
No liability can be accepted for accidents resulting from non-compliance with this
requirement or incorrect grounding.
Electric oven
Appliances must be installed in a workmanlike manner in accordance with the instructions in
this manual and locally applicable regulations. This manual will be handed over to the user after
installation.
Before connection, check :
ü Que l’alimentation électrique du réseau est compatible avec la tension et puissance de
l’appareil.
ü Que l’installation xe de l’utilisateur comporte un dispositif à coupure omnipolaire homologué.
Connection : ATTENTION :
- Cable insulation must be type 245 IEC 57 or 245 IEC 66
- La longueur des conducteurs du câble dalimentation entre le dispositif d’arrêt de traction et les
bornes doit être telle que les conducteurs actifs se tendent avant le conducteur de terre en cas de
traction sur le câble.
- If this unit is permanently connected to a xed electrical cable, the cable should be equipped with
a fault leak protector.
- If this unit is connected to a wall outlet, the outlet should be permanently
Unit with one gas oven or one electric oven :
- Remove rear cover S, figures【1】,【2】.
- Use a standard flexible cable to connect to terminal block T (fig.【3】&【4】).
- Secure the cable by means of cable clamp U (fig.【3】).
It is hazardous to put the appliance into service without connecting it to suitable
ground.
ELECTRIC CONNECTION
L
