812600
24
Zoom out
Zoom in
Previous page
1/36
Next page
MANUAL FOR USE AND MAINTENANCE
24 LSC 001 -UK- REV. 06
3.2 ALARM CONTROL
The appliance is run by a program that controls the correct operation of its functions and in case one or
more of these is not properly performed, the display will signal the relevant alarm message together with
an acoustic signal.
NOTE. Messages can be divided into two different types: blocking and non-blocking alarms.
Blocking alarms block the appliance completely and to make it work again, it is necessary to switch it
off completely and to switch it on again using the main switch (3).
The non-blocking ones do not block the appliance or its functions and it is necessary to press the button
to cancel them.
Loss of data
This alarm is not a blocking one.
It appears when the main running program of the appliance cannot nd the parameters set at installation
(temperature and dose settings) in the memory and therefore, the appliance will continue to operate but
with default data (standard).
(If this alarm appears, it is necessary to have the appliance reprogrammed by an authorised Service
Centre).
High temperature
This alarm is not a blocking one.
It appears when the main running program of the appliance recognises a boiler temperature value
that is 5 °C higher than the preset temperature. If this alarm appears, the static relays are temporarily
disconnected.
Temperature probe failure
This alarm is a blocking one.
It appears when the main control program of the appliance recognises that the boiler temperature sensor
is not operating within the correct range:
Temperature lower than 50 °C 20 minutes after switching on (manual or by timer) or in real time, during
normal operation; sensor disconnected
Temperature higher than 140 °C (only during normal operation); short circuited sensor (if this alarm
appears, call an authorised Service Centre immediately).
Automatic water lling system
This alarm is a blocking one.
It appears when the main control program of the appliance signals that the automatic water lling system
has been operating for more than 4 minutes (if the problem persists, switch off the appliance and contact
an authorised Service Centre).
Transformer failure
This alarm is a blocking one.
It appears when the main control program of the appliance signals that the power (24 V) of the transformer of
the solenoid valves is below 13 V (if this alarm appears, call an authorised Service Centre immediately).
AL00
AL01
AL02
AL03
AL04
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Spaziale RAPID at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Spaziale RAPID in the language / languages: English as an attachment in your email.

The manual is 1.91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info