696298

La Nordica Termocamino Base DSA Manual

27
Zoom out
Zoom in
Previous page
1/104
Next page
ENGLISH
BEAM PROTECTIONS
Considering the irradiation of the hearth, it is necessary to be particularly careful in protecting the beams while designing your stack. Consider
the proximity of beams to the external surfaces of the hearth, on one side, and the irradiation of the glass door, usually very close to the
beams, on the other side. In any case, it has to be considered that the internal or lower surfaces of this beam in ammable material must not
come in contact with temperatures higher than 65 °C. Picture 2 gives some examples of execution.
WARNING: We cannot be made liable for a wrong operation of the plant, when it does not comply with the provisions of
these instructions or when it uses additional products not suitable for this device.
DESCRIPTION
Denition: thermo-replace according to EN 13229.
La NORDICA thermo-replace are ideal for holiday ats and weekend houses or as auxiliary heating all year round. Wooden logs are used as
fuel. The appliance works as an intermittent operating appliance.
The appliance is composed of painted and galvanised sheet steel and cast iron. The replace is found inside the boiler, is built steel and is
reinforced using welded nails. The water in the heating system circulates in the boiler, which absorbs the heat produced in the replace.
The door with viewing window is tted on extendible ball bearing guides that guarantee the sturdy, quiet, and reliable operation of the
appliance. The counterweight for door raising is supported by two sturdy chains with respective pinions.
The ceramic glass window (resistant up to 700°C) of the door provides a lovely view of the burning ames and prevents sparks and smoke
from getting out.
ACCESSORIES
 
SERIES SERIES
Room heating takes place:
a) by radiation: the heat is radiated into the environment through the panoramic window and the hot external surfaces of the thermo-
replace;
b) by conduction: radiators or heat convectors of the centralised system fed by hot water produced by the boiler.

1A- PRIMARY air register (Picture 8)



The ash drawer has to be emptied regularly, so that ash cannot hinder the intake of primary air for the combustion. Primary air is also
necessary to keep re live.
During the combustion of wood, the primary air register must be opened only a few, since otherwise the wood burns quickly and
the device can overheat.
2A- SECONDARY air register (Picture 8)
When the bar is pushed to the back the passage of the secondary is completely open.
The secondary air, passing through the two lateral jambs of the front side, heats itself starting the double combustion and keeping at the
same time the glass clean ( with open register).
The adjustment of the registers necessary to reach the rated caloric yield is the following one:
Hourly consumption ( kg/h ) PRIMARY air SECONDARY air TERTIARY AIR
4,5 CLOSED OPEN PREADJUSTED
FLUE
Essential requirements for a correct operation of the device:
• the internal section must be preferably circular;
• be thermally insulated and water-proof and produced with materials suitable to resist to heat, combustion products and
possible condensates;
• not be throttled and show a vertical arrangement with deviations not greater than 45°;
• if already used, it must be clean;
• all the sections of the ue gas duct must be accessible to inspection;
• inspection openings must be provided for cleaning.
• observe the technical data of the instructions manual;
Should the ues have a square or rectangular section, internal edges must be rounded with a radius not lower than 20 mm. For the rectangular
section, the maximum ratio between the sides must be = 1.5.
A too small section causes a decrease of the draught. It is suggested a minimum height of 4 m.
The following features are FORBIDDEN and therefore they endanger the good operation of the device: asbestos cement, galvanized steel,
rough and porous internal surfaces. In Picture 3 gives some examples of execution.
For a correct installation please respect the sections/lengths of the ue shown in the technical data table. By installations
with dierent dimensions the ue must be suitably sized in accordance with EN13384-1.
27
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Nordica Termocamino Base DSA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Nordica Termocamino Base DSA in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 9,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info