811800
22
Zoom out
Zoom in
Previous page
1/60
Next page
Rossella Plus – Rossella Plus forno / Nicoletta – Nicoletta forno / Gisella
22
7192450 – EN
Among the others, the following cannot be burnt: remainders of coal, cut-outs, scraps of bark and
panels, humid wood or treated with varnishes, plastic materials; in this case the warranty on the
equipment expires.
Paper and carton must be used only for ignition. The combustion of wastes is forbidden and may damage
the stove and the chimney, causing health damages and claims by the neighbourhood owing to the bad
smell. The wood is not a fuel, which allows a continuous operation of the appliance, as consequence the
heating all over the night is not possible.
variety Kg/mc KWh/Kg moistness 20%
Beech 750 4,0
Oak 900 4,2
Elm 640 4,1
Poplar 470 4,1
Larch* 660 4,4
Spruce* 450 4,5
Scots pine * 550 4,4
*Resinous wood not suitable for the burning
ATTENTION: the continuous and protracted use of aromatic wood (eucalyptus, myrtle etc.) quickly
damages the cast iron parts (cleavage) of the product.
9. LIGHTING
IMPORTANT: the first time that the appliance is lit, there will be an odour given off (due to the drying of
the adhesives of the junction chord), which disappears after a short use. It must be ensured, in any
case, a good ventilation of the environment. Upon the first ignition we suggest loading a reduced
quantity of fuel and slightly increasing the calorific value of the equipment.
To make a correct first lighting of products treated with paints for high temperatures it is important to
consider the following points:
The materials of construction these products are not homogeneous, because parts in cast iron steel,
refractory and majolica coexist.
The products are subject to a non homogeneous temperature: from one side to the other the
differences on temperature go from 300° C to 500° C .
During its life the appliance must support alternate cycles of lighting and switching off in the same day
and cycles of intense utilization or absolute rest according to the seasons.
The new stove can be defined seasoned only after having been lighted several times, when the varied
elastic stresses of all materials and paints will be completed.
In particular after the initial lightings it will be possible to smell the emission of typical odors of metals
and still fresh paint. This paint, during its preparation has been fired at 250°C for a few hours and
before being perfectly incorporated with the metallic surfaces must go over the temperature of 350°C
more times.
During the ignition process it is therefore necessary to follow these instructions:
1. Make sure that there is a great circulation of air in the place where there is the stove.
2. During the initial lightings do not overload the combustion chamber (at least half of the quantity
indicated in the instruction manual) and keep the appliance ON for 6-10 hours continuously; the
registers must be less opened in comparison with the indication of the instruction manual.
3. Repeat this operation 4-5 times or more, according to your availability.
4. Afterward you can increase the load (following the instructions in the manual regarding the maximum
load) and keep it ON for long ignition periods. At the beginning try to avoid short cycles of ON/OFF.
5. During first ignitions no object must be laid on the stove and in detail on varnished surfaces. Varnished
surfaces must not be touched during heating.
6. After you have completed the “running in” you can use your product as the engine of a car, trying to
avoid abrupt heating with excessive loads.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Nordica Nicoletta Forno at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Nordica Nicoletta Forno in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3.32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info