811768
10
Zoom out
Zoom in
Previous page
1/48
Next page
ENGLISH
CHIMNEY FLUE
The sizing, installation and connection of the chimney ue to the boiler must be carried out by an authorised company of master
chimney sweepers according to European, national and local regulations.
The ue must develop a sucient draught to convey and transport combustion smoke outdoors at all operating speeds. It is important to
have an adequately sized self-sucient ue for the boiler to operate correctly.
TO STABILISE THE DRAUGHT IN THE FLUE, IT IS NECESSARY TO INSTALL AN ADDITIONAL AUTOMATIC DRAUGHT REGULATOR
ON THE FLUE PIPE OR IN THE CHIMNEY.
THE QUALITY OF COMBUSTION, THE HEAT OUTPUT AND THE SERVICE LIFE OF THE BOILER DEPEND ON THE DRAUGHT. Fireplace
draught is directly proportional to the diameter, height and coarseness of the internal wall. Smoke from another appliance must not ow into
the ue connected to the boiler.
WARNING: AS REGARDS THE CONNECTION TO THE CHIMNEY FLUE AND FLAMMABLE MATERIALS, REFER TO THE European,
national and local regulations. THE FLUE MUST BE AT A SUITABLE DISTANCE FROM FLAMMABLE OR COMBUSTIBLE MATERIALS
BY MEANS OF ADEQUATE INSULATION OR AN AIR GAP.
SMOKE DUCT
THE HEAT GENERATOR OPERATES WITH NEGATIVE PRESSURE AND IS EQUIPPED WITH AN OUTPUT FAN FOR SMOKE EXTRACTION. THE
GENERATOR MUST ONLY HAVE ONE DISCHARGE SYSTEM. IT IS NOT PERMITTED TO HAVE A FLUE THAT IS SHARED WITH OTHER DEVICES.
Components of the smoke extraction system must be selected based on the type of device to install and according to:
• UNI/ TS 11278 in the case of metal replaces, with special reference to the designation.
• UNI EN 13063-1 and UNI EN 13063-2, UNI EN 1457, .-UNI EN 1806: in the case of non-metal replaces.
• The smoke duct must be as short as possible.
• A T-tting must be installed with a condensation collection cap at the bottom of the vertical section. The vertical duct can either be
inside or outside the building. If the smoke duct is installed inside an existing ue, it must be certied for solid combustion.
• If the smoke duct is outside the building, it must always be insulated.
• It must be possible to inspect all sections of the smoke duct.
• Inspection openings must be provided for cleaning.
IT IS MANDATORY TO PROVIDE A “T FITTING WITH A CONDENSATE COLLECTION CAP
AT THE BASE OF THE VERTICAL SECTION SMOKE SUCTION FAN OUTLET.
CONNECTION MUST BE CARRIED OUT WITH STABLE, STURDY PIPES THAT COMPLY WITH ALL STANDARDS AND REGULATIONS IN FORCE
AND ACCORDING TO THE PROVISIONS OF LAW, AND SECURED WELL TO THE FLUE.
THE INTERNAL DIAMETER OF THE CONNECTION PIPE MUST CORRESPOND TO THE EXTERNAL DIAMETER OF THE SMOKE OUTLET
OF THE APPLIANCE.
CHIMNEY POT
Flue draught also depends on the suitability of the chimney pot.
CHIMNEY POTS MUST MEET THE FOLLOWING REQUIREMENTS:
• Have a useful output section of more than double the length of the replace/pipe system into which it is inserted
• Be constructed in such a way that rain and snow cannot penetrate into the replace/pipe system
• Be constructed in such a way that even in the case of winds from all directions and with any inclination, the evacuation of combustion
products (windshield terminal) is ensured.
FAILURE TO COMPLY WITH THESE REQUIREMENTS WILL INVALIDATE THE WARRANTY
1010
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Nordica LNK20 EVO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Nordica LNK20 EVO in the language / languages: English as an attachment in your email.

The manual is 4.22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of La Nordica LNK20 EVO

La Nordica LNK20 EVO User Manual - German - 48 pages

La Nordica LNK20 EVO User Manual - French - 48 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info