696162

La Nordica Isotta Evo Manual

23
Zoom out
Zoom in
Previous page
1/92
Next page
ENGLISH
ACCESSORIES
GIULIETTA x ISETTA EVO ISOTTA EVO ISOTTA FORNO
ISOTTA
FORNO EVO
VIOLA EVO VIOLETTA x
POKER
SERIES SERIES SERIES SERIES SERIES SERIES SERIES
GLOVE
SERIES SERIES SERIES SERIES SERIES SERIES SERIES
The heating of the environment is made by irradiation: through the panoramic glass and the external hot surfaces of the stove, the heat is
radiated into the environment. The device is equipped with registers of primary and secondary air by which it is adjusted the combustion air.
A - SECONDARY Air register Picture 6
Over the door of the hearth there is the secondary air control.
This regulator must be open (the lever must be moved to the right), especially for wood combustion, so that unburnt carbon undergoes
a post-combustion (see chapter NORMAL OPERATION).
Through this register it is possible to adjust the power of the stove. Leaving it slightly open, according to the ue of the chimney, it is
possible to keep the glass clean.
B - PRIMARY Air register Picture 6
With the thermostat (ISETTA EVO, ISOTTA EVO, VIOLA EVO) or valve (GIULIETTA x, VIOLETTA x) placed on the back of the right side of
the stove, it is adjusted the passage of air through the ash drawer and the grate in the fuel direction. The primary air is necessary for the
combustion process. The ash drawer must be regularly emptied, so that the ash does not obstruct the primary air entry. Through the
primary air the re is also kept alive.
During wood combustion, the register of primary air must be opened only for a while, because otherwise the wood burns fast and the
stove may overheat. For the correct arrangement (see paragraph NORMAL OPERATION).
The adjustment of the registers necessary to reach the rated caloric yield is the following one:
Mass of fuel hourly
kg/h
(A )
SECONDARY Air
(B)
PRIMARY Air
TERTIARY Air
GIULIETTA x 1,9 Picture 6 CLOSED PRE-CALIBRATED
ISETTA EVO 2,2 OPEN 5 mm CLOSED /
ISOTTA EVO 2,5 OPEN OPEN 5 mm /
ISOTTA FORNO 3,2 OPEN OPEN 5 mm /
ISOTTA FORNO EVO 2,6 Picture 6 CLOSED PRE-CALIBRATED
VIOLA EVO 2,2 OPEN 5 mm CLOSED /
VIOLETTA x 1,9 Picture 6 CLOSED PRE-CALIBRATED
C - IGNITION CONTROL Picture 6
Close --; Open + ( NO Isotta Forno EVO ) See chapter LIGHTING
Lighting Operation :
Open the secondary air register (A), primary air register (B), open the ignition control (C), light up the re.
After about 10 minutes, when the re is lighted, close the thermostat (B) and the ignition control (C) and adjust the combustion course
with the controls (A). The openings for air (primary and secondary) must be opened together just a little (you must open the eventual
buttery valve placed on the pipe of smokes exhaust). See chapter LIGHTING.
Load The Fuel:
Before opening the hearth door, open the ignition control (C), load the fuel, close the door and after about 5 or 10 minutes close the
control (C). IMPORTANT: we suggest you to open the door very slowly, to avoid the exit of smokes.
THE FLUE
Essential requirements for correct appliance operation:
• the internal section must preferably be circular;
• the appliance must be thermally insulated and impermeable and built with suitable materials which are resistant to heat,
combustion products and any condensation;
• there must be no narrowing and vertical passages with deviations must not be greater than 45°;
• if already used, it must be clean;
• all the sections of the ue gas duct must be accessible to inspection;
• inspection openings must be provided for cleaning.
• the technical data from the instruction manual must be respected;
If the ues are of a square or rectangular section, the internal edges must be rounded with a radius of not less than 20 mm.
For the rectangular section, the maximum ratio between the sides must be ≤ 1.5.
A section which is too small causes a reduction in draught. A minimum height of 4 m is advisable.
The following materials are FORBIDDEN and compromise the good operation of the appliance: asbestos cement, galvanised steel, rough and
porous internal surfaces. Picture 1 shows some example solutions.
For a correct installation please respect the sections/lengths of the ue shown in the technical data table. By installations
with dierent dimensions the ue must be suitably sized in accordance with EN13384-1.
23
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Nordica Isotta Evo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Nordica Isotta Evo in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 10,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of La Nordica Isotta Evo

La Nordica Isotta Evo User Manual - Dutch - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info